Whirlpool GC5SHEXNS01 Specifications download pdf (Page 7)

Connect Water Line to Refrigerator

1. Remove the shipping tape from gray, coiled water tubing on

the rear of the refrigerator.

2. Before attaching copper tubing to refrigerator, flush at least 2

quarts (1.9 L) of water through the copper tubing and into a

bucket to get rid of any particles in the water line.

3. Check for leaks around the saddle valve. Do not overtighten

clamp or sleeve. This will crush copper tubing.

4. Make connection to refrigerator.

Style 1: Slide the purchased nut then the purchased ferrule

onto the tubing. Push the tubing into the purchased coupling

as far as it will go. Slide the nut and ferrule forward. Tighten

the nut by hand. Then tighten it with a wrench two more

turns. Do not overtighten.

Style 2: Push the bulb end of the tubing into the water valve

as far as it will go. Slide the nut forward and finger tighten.

Tighten the nut by hand. Then tighten it with a wrench two

more turns. Do not overtighten.

1. Bulb

2. Nut (provided)

5. Turn shut-off valve ON.

6. Check for leaks. Tighten any nuts or connections (including

connections at the valve) that leak.

Plug in Refrigerator

1. Plug into grounded 3 prong outlet.

2. Move refrigerator into final position.

Level Refrigerator

IMPORTANT: All four leveling legs must contact the floor to

support and stabilize the full weight of the refrigerator.

Base Grille Removal

1. Open the refrigerator doors to 90°.

NOTE: Do NOT remove the Tech Sheets fastened behind the

grille.

2. Remove base grille if it is installed.

Style 1 - Screw-on Base Grille:

■ Find pockets located about 4 in. (10 cm) in from each end

of grille. Use screwdriver to remove the screw found in

each pocket.

Style 2 - Snap-on Base Grille:

■ Grasp the grille with both hands. Lift up and tilt the top of

the grille toward you.

Leveling Refrigerator

The roller adjusting bolts are located behind the base grille. The

refrigerator has four adjustable rollers (two front and two rear).

There are two sets of roller adjusting bolts found at the base of

the refrigerator on each side.

1. Rear Leveling Bolt (yellow)

2. Front Leveling Bolt (silver)

NOTE: The yellow bolt will adjust the rear of the refrigerator,

and the silver bolt will adjust the front of the refrigerator.

1. Line to Refrigerator

2. Nut (provided)

3. Bulb

4. Coupling (purchased)

5. Ferrule (purchased)

6. Nut (purchased)

1 2 3 4 5 6

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Failure to follow these instructions can result in

death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Whirlpool GC5SHEXNS01 Specifications Page 7

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GC5SHEXNS01