Whirlpool Maax Pearl Hot Tub User Manual download pdf (Page 9)

1. Observe the LCD and press the Select button. “Light Off” appears on the LCD.

2. Use the On/Off button to turn the jetted bath lighting on.

3. Use the Up and Down buttons to increase or decrease the intensity of the lighting, respectively. The light inten-

sity ranges between Lt6 (high) and Lt1 (low). By default, the light intensity is set to the highest intensity (Lt6).

Press and hold the Up and Down buttons to cycle to the higher or lower intensity settings.

4. Release the Up or Down button when the LCD displays your desired selection.

Setting the Timer

Note: You must set the Timer before you can operate the blower.

1. Observe the LCD and press and hold the On/Off button. Continue to press and hold the button while the LCD

cycles through the available Timer settings: 20, 25 or 30 minutes.

2. Release the control when the number of minutes you would like the Timer to run is displayed on the LCD. The

LCD alternately flashes the elapsed Timer run time and the water temperature (when water is present in the

bath).

Starting the Variable-Speed Pump or Blower, Adjusting Operating Speed and Activating the Massage Option

Note: A variable-speed pump or blower operates at six speeds ranging between Sp6 (high) and Sp1 (low).

1. Observe the LCD and alternately press and release or hold the Select button until the LCD displays the pump

or blower identifier. The pump or blower identifier as well as its operating state appears on the LCD, as follows:

Blower Off.

2. To start the pump or blower, observe the LCD and press the On/Off button to set the operating state to On. The

pump or blower starts at a default intermediate speed of SP3.

3. To adjust the operating speed of the pump or blower, observe the LCD then press and hold the Up or Down but-

tons to increase or decrease the speed, respectively.

4. To activate the Massage option, observe the LCD and alternately press and release or hold the Select button until

the LCD displays the pump or blower identifier. Press the Massage button. The pump or blower identifier as

well as the operating state “Pulse” appears on the LCD. It is not necessary to first set the pump or blower oper-

ating state to On before activating the Massage option. You can simply press the Massage button when the pump

or blower is OFF and the pump or blower starts in Massage mode.

Pausing and Resuming Bath Operations

You can pause and resume the bath operations as follows (the underwater light, if present and operating, remains

lit while the bath is in Pause Mode).

1. To pause bath operations, observe the LCD and press and hold the On/Off button until “Pause Mode” appears

on the LCD.

2. To resume bath operations, press the On/Off button. “Resume Bath” appears briefly on the LCD.

Tu rning Off the Bath Controls

You turn off the light or pump and blower one at a time or all at once. To turn off the accessories one at a time:

1. Observe the LCD and alternately press and release or hold the Select button until the LCD displays the light,

pump or blower identifier. The light, pump or blower identifier as well as its operating state appears on the

LCD.

2. Press the On/Off button to set the operating state of the light, pump or blower to Off.

To turn off all the accessories, including the timer but excluding the light, at the same time:

1. Observe the LCD and press the On/Off button. All operating accessories except the light stop and “System Off”

appears on the LCD.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Whirlpool Maax Pearl Hot Tub User Manual Page 9