Whirlpool AKZM 830/IX Instruction for Use download pdf (Page 15)

EN13

Brightness

To change the display brightness, proceed as follows:

1. Turn the “Browse” knob to display “BRIGHTNESS.

2. Press button : the display shows LOW, MID or HIGH depending on the level currently set.

3. Turn the “Browse” knob to increase or decrease brightness and confirm by pressing .

STARCLEAN™ CLEANING CYCLE

To keep the oven in best condition, carry out the STARCLEAN™ cleaning cycle after each use. The cycle

takes 35 minutes, including a cooling stage, and must be carried out as follows:

For the description of this function, see the section CLEANING and the functions table on page14.

1. Proceed with oven cold.

2. Wet the cellulose cloth provided under running water and wring it out so that it does not drip.

3. Open the oven door and remove the enamelled accessories.

4. Cover the bottom of the oven completely with the cellulose cloth.

5. Distribute 350 ml of water evenly on the cellulose cloth. A smaller or greater amount of water could

compromise proper functioning of the cycle.

6. Close the oven door.

IMPORTANT:To prevent steam coming out, do not open the door during the cycle.

7. Select the symbol with the functions knob: the word STARCLEAN™ appears on the display.

8. Press button to confirm the choice and start the cleaning cycle. To prevent steam coming out, do

not open the door during the cycle.

9. At the end of the cycle, remove the cellulose cloth and eliminate any residual water in the oven.

10. Then start cleaning using the sponge provided, moistened with hot water (cleaning could be

compromised if delayed by more than 15 minutes).

Particularly stubborn grime

To eliminate particularly stubborn grime, repeat the STARCLEAN™ cycle and add a few drops of neutral

detergent while removing the grime.

KEY-LOCK

This function can be used to lock the buttons and knobs on the control panel.

To activate it, press and at the same time for at least 3 seconds. When activated, the functions

associated with the buttons are locked and the display shows a key symbol. This function can also be

activated during cooking. To deactivate it, repeat the above procedure. When the key-lock function is

activated, the oven can be switched off by turning the knob to 0 (zero). In this case, however, the previously

selected function will have to be set again.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Whirlpool AKZM 830/IX Instruction for Use Page 15