Whirlpool Freestanding Gas Range W10531342A User Manual download pdf (Page 10)

6. Repeat steps 1 and 2 to ensure that the range foot is

engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor

without resistance, the anti-tip bracket may not be installed

correctly. Do not operate the range without anti-tip bracket

installed and engaged. Please reference the “Assistance or

Service” section of the Use and Care Guide, or the cover or

“Warranty” section of the User Instructions, to contact

service.

Level Range

1. Place a standard flat rack in oven.

2. Place level on the rack and check levelness of the range, first

side to side; then front to back.

3. If range is not level, pull range forward until rear leveling leg is

removed from the anti-tip bracket.

4. Use a ³⁄₈" drive ratchet and slip-joint pliers to adjust leveling

legs up or down until the range is level.

5. Push range back into position.

6. Check that rear leveling leg is engaged in the anti-tip bracket.

NOTE: Range must be level for satisfactory baking

performance.

Installing/Replacing the Battery

*NOTE: Metal battery top is included in the bag containing

literature.

To install or replace the 9V DC alkaline battery, follow the steps

below.

1. Open the broiler door.

2. Remove broiler pan and grill from broiler.

3. Using a Phillips screwdriver, remove the metal battery top

from the bottom of the range and open the plastic battery

box.

A. Battery holder location

A. Screw

B. Metal battery top*

C. Plastic battery box

D. Battery holder

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Whirlpool Freestanding Gas Range W10531342A User Manual Page 10