Whirlpool Freestanding Gas Range W10531342A User Manual download pdf (Page 9)

3. Use a combination wrench and pliers to attach the flexible

connector to the adapters. Check that connector is not

kinked.

Complete Connection

1. Locate gas pressure regulator in the broiler.

IMPORTANT: Do not remove the gas pressure regulator.

2. Check that the gas pressure regulator shutoff valve is in the

“ON” position.

3. Open the manual shutoff valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

4. Test all connections by brushing on an approved

noncorrosive leak-detection solution. Bubbles will show a

leak. Correct any leak found.

5. Close the broiler door.

6. Remove cooktop burner caps and grates from parts

package. Align notches in burner caps with pins in burner

base. Burner caps should be level when properly positioned.

If burner caps are not properly positioned, surface burners

will not light. Place burners, burner caps and grates on the

cooktop.

Verify Anti-Tip Bracket Is Installed and

Engaged

1. Place the outside of your foot against the bottom front of the

broiler, and grasp the lower right or left side of the control

panel as shown.

NOTE: If your countertop is mounted with a backsplash, it

may be necessary to grasp the range higher than is shown in

the illustration.

2. Slowly attempt to tilt the range forward.

If you encounter immediate resistance, the range foot is

engaged in the anti-tip bracket.

3. If the rear of the range lifts more than ½" (1.3 cm) off the floor

without resistance, stop tilting the range and lower it gently

back to the floor. The range foot is not engaged in the anti-tip

bracket.

IMPORTANT: If there is a snapping or popping sound when lifting

the range, the range may not be fully engaged in the bracket.

Check to see if there are obstructions keeping the range from

sliding to the wall or keeping the range foot from sliding into the

bracket. Verify that the bracket is held securely in place by the

mounting screws.

4. Slide the range forward, and verify that the anti-tip bracket is

securely attached to the floor or wall.

5. Slide range back so the rear range foot is inserted into the

slot of the anti-tip bracket.

IMPORTANT: If the back of the range is more than 2" (5.1 cm)

from the mounting wall, the rear range foot may not engage the

bracket. Slide the range forward and determine if there is an

obstruction between the range and the mounting wall. Changes

to the gas supply must be performed by a qualified service

technician. If you need assistance or service, refer to the

“Assistance or Service” section of the Use and Care Guide for

contact information.

A. Pressure regulator

connection fitting

B. Use pipe-joint compound.

C. Adapter

D. Flexible connector

E. Adapter

F. Use pipe-joint compound.

G. Manual shutoff valve

H. ½" or ¾" gas pipe

A. Gas pressure regulator

A. Closed valve

B. Open valve

Front ViewFront View

Side View

Shutoff valve

Front

“ON” Position

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments

Whirlpool Freestanding Gas Range W10531342A User Manual Page 9

Comments to this Manuals

Related products and manuals for Radio Whirlpool Freestanding Gas Range W10531342A