Whirlpool 50-Hz Models Specifications download pdf (Page 13)

106995-CA (1093)

Kohler Co., Kohler WI

9. FIELD WIRE ELECTRONICS

A. SERVICE REQUIREMENTS

The whirlpool controls and system have been prewired

at the factory. A licensed electrician should make a

routine service connection to the field wiring

compartment of the control box.

See Electrical Requirements section on page 7 of

Product Requirements. Dedicated services are required

for the whirlpool and heater.

WARNING: Risk of electrical shock. A licensed

electrician should make all electrical connections.

WARNING: Risk of electrical shock.

Disconnect and lock out power before performing

the following procedures. Refer to Important

Safety Instructions on page 2.

B. IDENTIFY ELECTRICAL REQUIREMENTS

The model number is printed on a plate at the pump end

of the module.

The model number identifies electrical rating. Electrical

connections for each model vary.

S K-1384-AC: 60 Hz, no heater

S K-1384-JA-AA: 50 Hz, no heater

S K-1384-H-AC: 60 Hz, w/heater

C. LOCATE FIELD WIRING COMPARTMENTS

1. Whirlpools without heaters are configured as

shown.

Loosen the screws on the control box cover and remove

cover.

Proceed with appropriate electrical connections.

Whirlpool Switch

Level Control Air Line

Field Wiring

Compartment

Pump

Suction

Control Box

Bonding (Earthing)

Lug (for bonding in ac-

cordance with national

and local codes)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Whirlpool 50-Hz Models Specifications Page 13