Whirlpool CEM2793BQ Specifications download pdf (Page 20)

ELECTRIC DRYER ELECTRICAL CONNECTIONS (FORU.S.A. ONLY)

Connecting 3=Wire Connection: Power Supply Cord

Standard Power Cord Connectors

Flanged Spade Connector RingConnector

2. Connect neutral wire (white or center wire)) (D) of power

supply cord under center terminal block screw (A). Tighten

screw.

Connecting Neutral Wire

1. Loosen or remove center terminal block screw (A).

3. Connect remaining wires under outer terminal block screws

(F). Tighten screws. Finally, reinstall terminal block to dryer

rear panel. Secure cover with hold-down screw.

" n

Connecting 4-Wire Connection: Direct Wire

IMPORTANT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of 3-wire

connections.

Direct wire cable must have 5 ft. (1.52 m) of extra length so

dryer can be moved if needed.

Strip 5" (127 mm) of outer covering from end of cable, leaving

bare ground wire at 5" (127 mm). Cut 11/2"(38 mm) from 3

remaining wires. Strip insulation back 1" (25 mm). Shape ends

of wires into a hook shape.

Connecting Neutral Ground and Neutral Wires

1. Remove center terminal block screw (A) and the neutral

ground wire (B) by removing the green external ground

conductor screw (C).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

No comments

Whirlpool CEM2793BQ Specifications Page 20