Whirlpool WET3300XQ User Manual download pdf (Page 20)

CONNECT DRAIN HOSE

Check the drain hose to see whether it is the proper length.

Wet the inside of the straight end of the drain hose with tap

water.

IMPORTANT: Do not use any lubricant other than water.

Squeeze ears of the silver double-wire clamp with pliers to

open. Place clamp over the straight end of the drain hose 1/4"

(6.4 mm) from the end.

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

1. Attach clamp to drain hose

¼"

(

6.4 mm)

3. Place drain hose in standpipe

4.5"

(114 mm)

Drain

hose form

Open clamp. Twist hose back and forth while pushing onto

drain connector on the side of the washer/dryer. Continue until

hose contacts the ribbed stops on the cabinet. Place clamp

over the area marked “CLAMP.” Release clamp.

2. Attach drain hose to drain connector

Proper connection of the drain hose protects your oors from

damage due to water leakage. To keep the drain hose from

coming off or leaking, it must be installed according to the

following instructions:

IMPORTANT: To ensure proper installation, this procedure

must be followed exactly.

For oor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See “Tools and Parts.”

4. Remove drain hose form

(oor drain installations only)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Whirlpool WET3300XQ User Manual Page 20