Whirlpool WFW560CHW Use and Care Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 71
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
12
PRELIMINARY
DRAFT
USING THE DISPENSERS (varies by model)
1. For automatic dispensing, open the bulk dispenser drawer
using the handle at the base of the washer. For a single load,
open the single load dispenser drawer at the top left corner
of the washer and disable the Load & Go™ option.
2. Add laundry products as described below.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
NOTES:
A small amount of water may remain in the single load
dispenser from the previous wash cycle. This is normal.
See “About Detergent Concentration” for information on
detergent concentration.
On some models:
When detergent in the bulk dispenser is
running low, the display will show the detergent level (Low).
Add single-dose and Oxi-type boosters to the drum before
loading items. See the “Using Your Washer” section.
Adding HE detergent to dispenser
Powdered detergent:
Lift the selector to the high
position. Add directly to the
compartment.
Use only High Efciency
(HE) detergent.
Load & Go
bulk dispenser (on some models)
Adding detergent for a single load
IMPORTANT:
Disable the Load & Go™ option before starting a single
load.
Do not add single-dose laundry packet to dispenser
drawer.
HE detergent
compartment
Use only High Efciency (HE)
liquid detergents. The bulk
dispensers will hold about 67.6 oz
(2 L) or 33.8 oz (1 L) of liquid HE
detergent, depending on dispenser,
or enough for many loads of laundry.
To Fill Bulk Dispeners:
Open the dispenser drawer by pulling on the handle at
the base of the washer. If desired, the drawer can be
completely removed from the washer.
Locate the Load & Go™ bulk
dispenser. Gently pull up on the
tab located on the bulk dispenser
lid to lift the ll door.
Fill to the “MAX” line (see
illustrations at right) with HE
liquid detergent. Close ll door.
It will click into place. Make sure
the concentration is correct (see
the “Choosing the Right Detergent”
section.
The dispensers should be rinsed out
when changing detergents or when
the washer will not be used for
extended periods. For instructions
on cleaning the dispenser cartridge,
see the “Washer Care” section.
Use only High
Efciency (HE)
detergent.
Liquid detergent:
Push down the selector
to the low position. Add
directly to the compartment.
Selector
Pour a measured amount of HE detergent into detergent
compartment. For powdered detergent, lift the selector
to the high position. For liquid detergent, push down the
selector to the low position.
Do not overll; adding too much detergent may cause
detergent to be dispensed into the washer too early.
Tab
“MAX” line
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Comments to this Manuals

No comments