Whirlpool WT640 User Manual download pdf (Page 5)

Installation

Remove the transit fixings

IMPORTANT: Follow these instructions to remove the

TWO transit fixings (see Description for location).

! Situated on either

side of the rear

panel,

BOTH transit bolts

MUST be removed

before use.

! Failure to do so may cause damage to your machine.

! I

t is important the transit fixings and spacers come out intact.

! Be sure to remove: TWO bolts,

TWO washers, TWO rubber

grommets and TWO nylon

spacers (see pic.)

1. Unscrew the bolt using a

13mm spanner

STOP when 3 threads can be

seen.

Did you know?

 the transit fixings are fitted to ensure that your machine is undamaged during delivery.

 both of the transit fixings MUST BE removed before using the machine, be sure to remove TWO

bolts, TWO washers, TWO rubber grommets and TWO nylon spacers, not doing so will lead to

excessive vibration, movement of the machine and could eventually lead to internal damage.

 the majority of problems with noisy machines are due to the transit fixings not being removed,

closely followed by the feet not being adjusted correctly to level the machine.

 you will be charged for a service engineers visit if a problem with your machine is caused by

incorrect installation or misuse.

3. Hold, slide sideways and pull to

remove.

4. For safety, insert both

yellow plastic covers

(supplied with your machine)

over the holes.

! Repeat steps 1 to 4 to remove the second transit bolt.

! Packaging materials are not childrens toys.

Location

Where you install your machine will affect its

performance:

! For your safety and to comply with electrical

regulations, seek professional advice if you want to

install your machine in a bath or shower room.

 Make sure that the electrical socket and water

taps are easily accessible. You should switch off

the machine's electrical and water supplies

when you are not using it for extended periods.

 Make sure that you allow enough space for the

machine. Select a space at least 60 cm wide,

60 cm deep and 85 cm high. Also leave enough

space to open the door fully, so that you can load

and unload it easily.

 Where possible, the machine should be positioned

on a solid floor to minimise vibration.

! Take care when you move the machine not to rip any

floor coverings. The weight of the machine may cause

indentations in some floor coverings.

Location of transit bolts

(see arrows)

bolts

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Whirlpool WT640 User Manual Page 5

Comments to this Manuals

Related products and manuals for Washing machines Whirlpool WT640