RECHARGE NOW initiated
RECHARGE NOW
The RECHARGE button is used to initiate an immedi-
ate recharge.
1. Press and hold the RECHARGE button until the
words “RECHARGE NOW" flash in the display.
The softener enters the fill cycle of regeneration right
away. “RECHARGE NOW” will flash during the
regeneration. When completed, full water condition-
ing capacity is restored. While water softener is run-
ning a recharge, the time remaining until the recharge
is completed will show in the display during all cycles
except for the Fill cycle.
NOTE: Avoid using hot water while the softener is
regenerating, because the water heater will
refill with bypass hard water.
RECHARGE TONIGHT
If you do not want to start an immediate recharge, but
would like to schedule an extra recharge at the next
preset recharge time, do the following:
1. Press and release (do not hold) the RECHARGE
button.
FIG. 19
13
Programming the
Water Softener
(Model WHES20)
SET RECHARGE (REGENERATION) TIME
1. Press the PROGRAM button once again to display
a flashing “2:00AM” and the words “RECHARGE
TIME”. This is a good time for the recharge to start
in most households, because water is not in use.
2. If you want to change the recharge start time,
press the r UP or s DOWN buttons until the
desired time shows. Be sure AM or PM is correct.
3. Press the PROGRAM button once again, to return
to the normal time of day display.
START A RECHARGE
1. Press the RECHARGE button and hold for three
seconds, until “RECHARGE” begins to flash in the
display, starting a recharge. This recharge draws
the sanitizing bleach into and through the water
softener. Any air remaining in the water softener is
purged to the drain. During this time, periodically
check for leaks.
NOTE: As with all other water system applications,
leaks may occur. Leaks may not be immedi-
ately apparent. Recheck for leaks 24 hours
after first recharge cycle is complete.
FIG. 18
Customizing
Features / Options
(Model WHES20)
The words “RECHARGE TONIGHT" flash in the dis-
play, and the softener will recharge at the next
recharge time. The words “RECHARGE NOW" will
flash during the regeneration. When completed, full
water conditioning capacity is restored.
RECHARGE TONIGHT initiated
FIG. 20
POWER OUTAGE MEMORY
If electrical power to the water softener is lost, “mem-
ory'' built into the timer circuitry will keep all settings
for up to six hours. While the power is out, the dis-
play is blank and the water softener will not regener-
ate. When electrical power is restored, the following
will occur:
Reset the present time only if the display is flashing.
The HARDNESS and RECHARGE TIME never
require resetting unless a change is desired. Even if
the clock is incorrect after a long power outage, the
softener operates as it should to keep your water soft.
However, regenerations may occur at the wrong time
of day until you reset the clock to the correct time of
day.
NOTE: If the water softener was regenerating when
power was lost, it will now finish the cycle.
(40 pages)
(35 pages)
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals