Whirlpool WGFD29 User Manual download pdf (Page 4)

RODUCT

PECIFICATIONS

4 www.whirlpoolcomfort.com WGFM29 / WGFD29.00

WGFM29 DIMENSIONS

MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS

Position Sides Rear Front Bottom Flue Top

Upﬂ ow 0” 0” 3” C 0” 1”

Horizontal 6” 0” 3” C 0” 6”

ÁÁ

Notes:

• For servicing or cleaning, a 24” front clearance is required.

• Unit connections (electrical, ﬂ ue and drain) may necessitate greater clearances than the minimum clearances listed above.

• In all cases, accessibility clearance must take precedence over clearances from the enclosure where accessibility clearances are greater.

Model A B C D E

WGFM29045V3BX

 

¹⁄₈¹⁄₈⁵⁄₈

WGFM29070V4BX

 

¹⁄₈

 

WGFM29090V5DX

 

⁵⁄₈³⁄₈⁷⁄₈

WGFM29115V5DX

 

⁵⁄₈³⁄₈⁷⁄₈

Notes:

• Installer must supply one or two PVC pipes: one for combustion air (optional) and one for the ﬂ ue outlet (required). Vent pipe must be either 2” or

3” in diameter, depending upon furnace input, number of elbows, length of run and installation (1 or 2 pipes). The optional Combustion Air Pipe is

dependent on installation/code requirements and must be 2” or 3” diameter PVC.

• Line voltage wiring can enter through the right or left side of the furnace. Low-voltage wiring can enter through the right or left side of furnace.

• Conversion kits for high-altitude natural gas operation are available. Contact your Goodman distributor or dealer for details.

• Installer must supply following gas line ﬁ ttings, according to which entrance is used:

Left—Two 90º elbows, one close nipple, straight pipe

Right—Straight pipe to reach gas valve

• For bottom return: Failure to unfold ﬂ anges may reduce airﬂ ow by up to 18%. This could result in performance and noise issues.

28 3/4

19 7/8

RIGHT SIDE VIEW

LEFT SIDE VIEW

22 1/16

FOLDED FLANGES

23 9/16