Whirlpool 11-0086-11 Owner's Manual download pdf (Page 37)

MAINTAINING YOUR SPA cont...

REMOVING, INSTALLING AND CLEANING FILTERS

These are the steps needed to successfully replace your lters You

should replace your disposable spa lters and clean your nondispos-

able lters every four months.

1) Turn off all power to your spa and re-

move the lter lid by lifting it out towards

you.

2) Turn the lter counterclockwise and re-

move it from the lter well.

3) Dispose of the used lter.

4) To replace, set screen back into its place

turn clockwise to fasten. DO NOT\ over-tighten.

5) Place the new lter into position and

turn clockwise to fasten. DO NOT over-

tighten.

6) Follow the directions 1) and 2) for the

pleated lter cartridge. You then rinse the

lter with a garden hose and soak the lter

in a mixture of one pint of lter cleaner with

2.5 gallons of water for at least 12 hours.

The lter must be completely submerged. You then follow the directions

4) and 5) to replace the lter

WARNING: Power to your spa must be turned off prior to remov-

ing your lters. The suction at the lter is extremely strong and

can cause injury if there is no lter. NEVER run your spa without

the lters properly installed. Injury to person and damage to the

equipment can occur. Any damage to equipment due to this cir-

cumstance will not be covered under warranty.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 65 66

No comments

Whirlpool 11-0086-11 Owner's Manual Page 37