Whirlpool 850 Series Owner's Manual download pdf (Page 18)

• Remove hose and replace filter cartridge as illustrated in section 11.1,

page 36 (Step-G).

C. Turn On Power

Turn on power to hot tub at the home’s circuit breaker. The heater and

circulation pump will automatically activate. If the control panel LCD

flashes water temperature and “COOL” or “ICE”, the pump 1 will also

activate in low speed. If this occurs, refer to page 43 for additional

information.

D. Activate Jets

Depress the JETS 1 sensor pad on the control panel twice to

activate pump #1 in high speed and initiate maximum water

flow to certain jets.

E. Add Start-Up Chemicals

Add the hot tub water chemicals as recommended by your Sundance

Dealer. See section titled WATER QUALITY MAINTENANCE (page 40) for

general guidance.

F. Set Hot Tub to Heat

To warm hot tub water to a comfortable temperature, follow these

steps:

• The LCD display on the control panel displays the actual temper-

ature of the hot tub water. Press either the COOLER (Down) or

WARMER (Up) sensor pad once to display the “set temperature”

for 5 seconds. If you want the water to heat to a different temperature,

simply press COOLER (Down) or WARMER (Up) within 5 seconds. The

set temperature advances or decreases by one degree each time one of

these sensor pads is pressed.

• The heater will turn off when the temperature corresponding to the

thermostat setting is achieved.

Important Heater Details:

•The maximum temperature for which the hot tub can be set is 104 ˚F (40 ˚C)

and the minimum is 80 ˚F (27 ˚C).

•If hot tub is hooked to a 30 amp service - turn off all high speed pumps

and blower to operate heater. Note: pump #2 runs only in high speed.

•Setting the thermostat at maximum will not accelerate the heating process.

This will only result in a higher ultimate temperature.

• The heater operates until the water reaches the programmed “set

temperature” , then turns off. The heater will reactivate after the water cools

to approximately 1.5° below the “set temperature.”

Page 14

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

No comments

Whirlpool 850 Series Owner's Manual Page 18