Whirlpool 850 Series Owner's Manual download pdf (Page 37)

Page 33

(4) Press DISPLAY to make the skimming/heating cycle programming char-

acters disappear from the screen and the main display return to showing the

water temperature. If no sensor is pressed within 30 seconds, the screen auto-

matically returns to the standard water temperature display.

At any time, you may check the programming of any aspect of any skim-

ming/heating cycle by first pressing CYCLE then moving through the menu

by pressing either CYCLE or SELECT. The programming is changed only by

pressing UP or DOWN during this process.

10.3 Programming The Change Filter Reminder

Your new spa is equipped with a programmable “Change

Filter” reminder that appears on the control panel display after

a specified number of days. It is designed to remind you to

clean and/or replace your filter cartridge(s) on a regular basis but does not

affect spa operation in any way. This reminder must be reset at each filter

cleaning interval. It offers a selectable range from 10-120 days or can be

disabled. W

e r

ecommend an initial setting of 30 days, after which you can

easily determine whether you need to shorten or lengthen its interval by

visually inspecting your filter cartridge. Refer to section 11.1 (page 35) for

filter cleaning recommendations.

Programming Instructions

(1) Press the CYCLE sensor six times

. The main display reads “FIL”

indicating the “Change Filter” display program has been accessed.

(2) Press SELECT sensor once to display currently programmed duration or

days elapsed since last filter cleaning interval.

(3) Press UP or DOWN sensor to change duration as follows:

0 - 10 - 20 - 30 - 40 - 50 - 60 - 70 - 80 - 90 - 100 - 110 - 120 - OFF

(4) Press DISPLAY sensor once to save changes and return to the

standard water temperature display. Note: If no sensor is pressed

within 30 seconds, the screen will automatically return to the standard

water temperature display.

10.4 Programming Circulation Pump Run Time

The Sentry control system allows you to easily adjust two separate aspects

of circulation pump operation:

1. The time of day (start time) the circulation pump begins operating.

2. The length of time (duration) the circulation pump operates.

The factory default start time is 12:00AM (Midnight). The default duration

is 24 hours. To make adjustments, press the sensor labeled CYCLE fiv

CHANGE

FILTER

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 52 53

No comments

Whirlpool 850 Series Owner's Manual Page 37