Whirlpool SF335ESR/ER User Manual download pdf (Page 14)

Surface Burners

Lift up the cooktop, following the instructions on poge13.

Wipe off surface burners with warm soapy water and a soft cloth after each

use.

Occasionally check surface burner flames for size and shape as shown. If

flames do not burn properly, you may need to remove the surface burners for

cleaning (see pagel7), or call a qualified technician for burner adjustments.

To adjust the LO settings on the control knobs:

1. Turn on the surface burners, then set the controls on LO.

2. without changing the burner settings, remove the control knobs.

3. Firmly grasp the control stem and insert a small bladed screwdriver into

the end of the stem. Turn the screwdriver in either direction until the flame

height is Va in (.318 cm) or lower in size. Flame must be large enough to

maintain a STABLE FLAME on all burner ports.

NEVER ADJUST THE FLAME SIZE AT THE MEDIUM SEHING.

The Oven Door

Removing the oven door will make it easier to clean the oven.

WARNING: To avoid

burns, be sure the

oven is OFF and COOL.

Open the door to the first stop

position.

2. Hold the door at both sides and lift

off of hinges at bottom corners of

door.

3. To replace, fit the bottom corners

of the door over the ends of the

hinges.

Push the door down evenly. The

door will close only when it is on

the hinges correctly.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Whirlpool SF335ESR/ER User Manual Page 14