Whirlpool UXL6048YSS Use and Care Guide download pdf (Page 11)

Complete Preparation

1. Determine and make all necessary cuts for the vent system.

IMPORTANT: When cutting or drilling into the ceiling or wall,

do not damage electrical wiring or other hidden utilities.

2. Determine the location where the ¹⁄₂" (1.3 cm) wiring conduit

will be routed through the ceiling or wall between the in-line

blower and the hood liner.

3. Drill a 1¹⁄₄" (3.2 cm) hole at this location.

4. Locate the electrical terminal boxes in the in-line blower

housing and hood liner. Remove the terminal box covers and

set the covers and screws aside.

5. Remove the electrical knockout from the in-line blower

housing and hood liner to prepare for the installation of the

UL listed or CSA approved ¹⁄₂" (1.3 cm) wiring conduit and

conduit connector.

6. With the hood liner mounted (see the “Install Hood Liner”

section), run the ¹⁄₂" (1.3 cm) wiring conduit between the in-

line blower motor housing and the hood liner. Pull enough

¹⁄₂" (1.3 cm) wiring conduit to allow for easy connection to the

terminal boxes in the in-line blower housing and hood liner.

7. Run the six 18 AWG wires through the ¹⁄₂" (1.3 cm) wiring

conduit and conduit connectors and into the terminal boxes

on the in-line blower housing and hood liner. Leave enough

wire length in each terminal box to make the wiring

connections.

8. Install the conduit connectors and conduit to the in-line

blower housing and hood liner electrical terminal boxes.

9. Connect the vent system to the hood liner and in-line blower

system and seal all joints with clamps.

Make Electrical Connections for In-Line

Blower Motor System

Electrical Connection Inside In-line Blower System

1. Disconnect power.

2. Connect the wires from the wiring conduit to the wires from

the motor electrical plug cable inside the in-line blower

housing terminal box.

3. Use UL listed wire connectors and connect the black wires

4. Use UL listed wire connectors and connect the white wires

(D) together.

5. Use UL listed wire connectors and connect the red wires (E)

together.

6. Use UL listed wire connectors and connect the blue wires (F)

together.

7. Use UL listed wire connectors and connect the gray wires (G)

together.

A. Electrical terminal box

B. Electrical knockout

A. UL listed or CSA approved

¹⁄₂

" (1.3 cm) wiring conduit

B. UL listed wire connectors

C.Black wires

D. White wires

E. Red wires

F. B lu e w i r es

G. Gray wires

H. Green (or yellow/green)

and green/yellow wires

I. Motor electrical plug cable

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1 ... 10 11 12 ... 36

Comments to this Manuals

No comments

Whirlpool UXL6048YSS Use and Care Guide Page 11

Comments to this Manuals

Related products and manuals for Cooker hoods Whirlpool UXL6048YSS