Whirlpool HUD61X S Instruction for Use download pdf (Page 8)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Electrical Connection

Warning - THIS APPLIANCE MUST BE EARTHED

The cooker must be connected by a qualified

electrician to a suitable double - pole control unit

with a minimum rating of 32A and a minimum

contact clearance of 3mm, which should be fitted

adjacent to (but not above) the cooker, in

accordance with IEE regulations.

The power supply cable should conform to BS6004

with a conductor size of 6mm

The control unit should be easily accessible in the

event of an emergency.

This appliance conforms to EN55014 regarding

suppression of radio and television interference.

Access to the cooker terminals is by un-clipping the

cover. The mains cable must pass through the cable

clamp and the screws must be fully tightened.

Sufficient cable should be used to allow the cooker

to be pulled out for servicing. Ensure that the cover

is fully closed and secure afterwards.

Take care not to trap the mains cable when pushing

the cooker into its final position.

Operational Checks

After installation, check for gas soundness. The

supply pressure can be checked at one of the

hotplate burner injectors.

Check that the hotplate burners ignite correctly

and burn with a steady flame.

Check for a steady flame at the low setting.

Instruct the user on the operation of the cooker.

WARNING – THIS APPLIANCE MUST BEWARNING – THIS APPLIANCE MUST BE

WARNING – THIS APPLIANCE MUST BE

EARTHED.EARTHED.

EARTHED.

Electrical connection

Electric cookers come without a power supply cable.

The cooker is designed to operate on an electricity

supply which conforms to the electrical data shown

on the Rating Plate. The cooker can be connected to

the mains only after removing the back panel of the

cooker itself with a screwdriver.

N.B.:N.B.:

N.B.: the following installation procedure must be

carried out by a qualified electrician. The electrical

installation must comply with the IEE Regulations,

Building & local By-Lays.

For the installation of the feeding cable carry out the

following operations:

1 Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the screwdriver as

a lever by pushing it

down to open the cover

(see diagram).

2 Loosen the cable

clamp screw and

remove it, using a

screwdriver as a lever

(see figure).

3 Remove the wire

contact screws L-N-

then fasten the wires

under the screw heads,

respecting the colour

code: Black/Blue (N),

Red/Brown (L) and Bare Wire/Yellow-Green (

)

l Once the connections have been made, tighten

all the terminal screws fully.

l Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

1 2 3 4 5 6 7 8 9 ... 28

Comments to this Manuals

No comments

Whirlpool HUD61X S Instruction for Use Page 8

Comments to this Manuals

Related products and manuals for Cookers Whirlpool HUD61X S