Whirlpool TPM114 Instruction for Use download pdf (Page 19)

Electrical connection

THE APPLIANCE MUST BE EARTHED

The cooktop is designed to work with alternating current at

the supply voltage and frequency indicated on the rating

plate (situated under the hob or at the end of the instruction

booklet). Make sure that the local supply voltage

corresponds to the voltage indicated on the rating plate.

The electrical cooktop is not supplied with a power supply

chord because the type of chord used depends on the type

of electrical connection (see the following connection

diagram).

Use a rubber cable of the type H05VV-F.

Open the terminal box following the instructions illustrated

in the diagram below:

To connect the supply chord, proceed as follows:

l Loosen the screws on the wire clamp “V”, as well as

the screws for the contacts.

l Insert the wires beneath the contact screws, as shown

in the diagram, and tighten them.

l Fasten the chord with the appropriate wire clamp and

close the cover.

lacirtcelE

noitcennoc

egatlovylppusrewoPesuFnoitceS

zH06/05~N+1-V032

A23²mm4

zH06/05~2-V032

A23²mm4

zH06/05~N+-V004

A52²mm5.2

zH06/05~3-V032

A52²mm5.2

zH06/05~N+3-V004

A61²mm5.1

zH06/05~N2+2-V032

A52²mm5.2

Connecting the supply cable to the mains

Fasten the appropriate standard plug for the load indicated

the rating plate to the chord. If the appliance must be directly

connected to the mains, a multipolar switch must be installed

between the appliance and the mains. The multipolar switch

must have a minimum of 3 mm of space between the

contacts, be sized to the load, and comply with current

regulations (the switch must not be able to disconnect the

earth conductor). The supply cord must be positioned so

that no part of it reaches a temperature of 50 °C higher

than room temperature. Before making the connection, make

sure that:

l the limiter valve and the residential wiring can support

the appliance load (see rating plate);

l the mains system is properly earthed in compliance with

current regulations and provisions;

l there is easy access to the socket or the multipolar

switch after the appliance is installed.

Attention: If the cooktop is installed above a built-in oven,

the electrical connection for the cooktop must be

independent of that for the oven, both for safety reasons

and to facilitate the removal of the oven for maintenance,

repair, etc.

2345

L1 L2

2345

L1 L2 L3

2345

L1 L2 L3

2345

L1 L2 N1

2345

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments

Whirlpool TPM114 Instruction for Use Page 19

Comments to this Manuals

Related products and manuals for Cookers Whirlpool TPM114