Whirlpool AD50GUSB Use and Care Manual download pdf (Page 11)

Check and make sure the drain hose is correctly connect to

Pump system does not work

Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.

Dehumidifier will not run

Is the dehumidifier turned on?

Turn on the dehumidifier.

Is the power cord plugged into a grounded three-prong outlet?

Has a household fuse blown or has a circuit breaker tripped?

continues, call an electrician. See “Electrical Requirements.”

■

Is the bucket installed properly?

■

Does the bucket need to be emptied?

■

Is the water level float in place?

Remove the bucket. Make sure the float is snapped

■

Is the control set to Continuous?

■

Plug into a grounded three-prong outlet. See Electrical Requirements.

Replace the fuse or reset the circuit breaker. If the problem

■

Reinstall the bucket so that it fits all the way into the dehumidifier.

Empty the bucket.

in place. Reinstall the bucket.

the compressor will cycle back on.

will run continuously. If the humidity level is low, little or

Clean the filter.

Air coming from dehumidifier is warm

■

operating conditions.

Dehumidifier displays trouble code

■

displays E1,E2 ...

If the dehumidifier displays trouble code, the unit will still

work. But please contact the customer service.

TROUBLESHOOTING

Dehumidifier runs but does not dehumidify

All models have an automatic de-icer that will shut off

The filter is dirty or obstructed by debris.

Ice forms on coils

■

the correct operating temperature.

All models have an automatic de-icer that will shut off the

the compressor and allow the fan to run.

This reduces the ice build-up on the coils.

The compressor will cycle back on when the de-icer senses

the compressor and allow the fan to run.

When the de-icer senses the correct operating temperature,

If you have selected Continuous Run, the dehumidifier

no water may be collected.

Dehumidifier will put out warm air under normal

Electrical Shock Hazard

Plug into a grounded three-prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire or electric shock.

WARNING

Does the pump indicator flash?

2. Press the POWER button to turn off the unit. Restart the unit

the unit.

by pressing POWER button again.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments

Whirlpool AD50GUSB Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Dehumidifiers Whirlpool AD50GUSB