Whirlpool ADG 6353 A+ PC FD Instruction for Use download pdf

GB -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required program lights

up (see “Table of programs”

below).

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program. When the door is opened during a

washing cycle, the cycle is temporarily paused: the

Start indicator blinks.

To resume the cycle push the Start button and

close the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute. If

pressed when the dishwasher is switched off it

drains any possible liquids from dishwasher (1

minute process).

If the indicator flashes repeatedly, see page 6 -

chapter ”What to do if...”.

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may

vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic

calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/

Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deterg

ent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Auto Sensor 50°-65°C

Delay

Power Clean

Recommended program for

routine washes, with dried-on

food (e.g. EN 50242)

X 7-14 1.00-1.60 70-155 Full

Rapid 45°C

Delay

Lightly soiled crockery, with no

dried-on food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Power Clean

Normally soiled crockery. Energy-

saving program.

X 11.5 1.03 170 Full

Hygiene

Delay

Power Clean

Normally or heavily soiled

crockery, with additional

antibacterial wash. Program

interruption (e.g. due to door

opening) can compromise

elimination of germs.

X 13.0 1.50 118 Full

Intensive 65°C

Delay

Power Clean

Recommended program for

heavily soiled crockery, especially

suitable for pans and saucepans.

X 14.0 1.60 145 Full

5019 396 03775

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir

needs to be refilled.

RINSE AID INDICATOR

When lit (at the end of the

cycle), the rinse aid

dispenser needs to be

refilled.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

POWER CLEAN BUTTON

Thanks to the additional power

jets this option provides a more

intensive and powerful wash in

the lower rack, in the specific

area. This option is

recommended for washing

pots and casseroles (see page

4). Press this button to activate

Power Clean (the indicator

lights up).

TABLET SETTING

This setting allows to optimize the cycle performances

according the type of detergent used.

Push the Tablet button for 3 seconds (until the indicator

lights up) if you are using the combined detergents in

tablet (rinse aid, salt and deteregent in 1 dose).

If you are using powder detergent or liquid detergent,

the Tablet indicator on the control panel has to be off.

DELAYED START

BUTTON

The wash cycle can be

programmed to start

after 2, 4 or 8 hours.

Then press the Start

button. The wash

program will start after

the set time.

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 03775

GB -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “Programs” button (repeatedly) until the indicator of the required progr

Page 2 - Daily check

GB -2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to use Power Clean

GB -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Page 5 - Maintenance and care

GB -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A