Whirlpool is a registered trademark of Whirlpool USA
5019 396 01083
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1
GB
ADG 673
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on
the EN comparison test and other
tests, contact the following address: “[email protected]”.1. OVERVIEW
ON button
OFF button
Delayed start button
Press the button repeatedly to delay the
start of the programme by 3, 6 or 9 hours.
Then press the Start button. The
dishwasher will start after the set time.
Detergent setting upon initial use and when using a different type of
detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
“3h” = 2in1, “6h” = 3in1, “9h” = other combined action detergents
(In this way the rinse aid and/or salt indicator is deactivated). All 3
LEDs light up = Powder detergent (factory setting).
4. Switch the appliance off and then switch it on again. The selected
detergent type will be indicated on the display for approx. 3
seconds. by the corresponding LEDs.
Programme selection button
Press the button repeatedly until the desired programme
indicator lights up.
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected
programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions
are given in chapter 5 “What to do, in the event of...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Table 1.1.
Programme chart
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Loading instructions large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. — — 5,0 0,02 10
2
Quickwash 40°C
Lightly soiled crockery with no
dried-on food.
X — 13,0 0,70 30+/-
1)
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme with
prolonged drying cycle.
X X 16,0 1,05 195+/-
1)
4
Daily 60°C
Normally to heavily soiled
crockery.
X X 16,0 1,35 120+/-
1)
5
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X X 17,0 1,65 145+/-
1)
Comments to this Manuals