Whirlpool ADG 7633 FD A++ Instruction for Use download pdf

EN -1-

Whirlpool is a registered trademark of Whirlpool USA

Chart

RINSE AID INDICATOR

When lit (at the end of the cycle), the

rinse aid dispenser needs to be refilled.

5019 300 02245

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir needs

to be refilled.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it

indicates the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” next page.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of detergent

used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in tablet

(rinse aid, salt and deteregent

in 1 dose).

If you are using powder

detergent or liquid detergent,

the Tablet indicator on the

control panel has to be off.

START/RESUME BUTTON

Push this button to start the

selected program: the indicator

lights up and goes off at the end of

the program.

When the door is opened during

a washing cycle, the cycle is

temporarily paused: the Start

indicator blinks.

To resume the cycle push Start

button and close the door

within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the

control panel.

If pressed when a program is

running it cancels the program

ongoing draining water for

1 minute (0:01 is shown into

the display).

If pressed when the

dishwasher is switched off,

it drains any possible liquids

from dishwasher (1 minute

process).

HALF LOAD BUTTON

Half load cycle can be used for

the upper or lower rack.

Select the required program

then press the “Half Load”

button - the light comes on.

Turns off at the end of the

program.

The “Half Load” option can be

used with the programs

indicated in the table of

programs.

DELAYED START BUTTON

Push the button (repeatedly) to

delay the start of the program -

delay indicator turns on.

Adjustable from 1 to 24 hours.

With each press of the button,

the delay increases by one hour

and after “h 24” returns to

“h 00”.

When this option is selected

the delay indicator turns on.

Then press the START button.

The dishwasher will start after

the set time.

Quick reference guide

1 2 ... 12

Summary of Contents

Page 1 - 5019 300 02245

EN -1-Whirlpool is a registered trademark of Whirlpool USAChartRINSE AID INDICATORWhen lit (at the end of the cycle), the rinse aid dispenser needs to

Page 2 - Table of programs

EN -10-What to do if...Crockery and cutlery... Possible causes... Solutions...are not perfectly clean/have food residues- Too little space between

Page 3 - Daily check

EN -11-What to do if...Crockery and cutlery... Possible causes... Solutions...have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce,

Page 4 - Daily use

EN -12-Precautions and general recommendations1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol .2. Removing

Page 5 - How to load the racks

EN -2-Chart1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary

Page 6

EN -3-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 7

EN -4-Daily check3Daily useAdding detergent - Use only detergent specifically for dishwashers in accordance with the supplier’s recommendationsOpen th

Page 8 - Maintenance and care

EN -5-How to load the racks4Load cutlery with the handle into the pins.Knives or cutlery with bulky handle can beloaded with the head into the pins.Ho

Page 9

EN -6-How to load the racks4CCLICK!Rotate the flapclockwise andhook on rackA - OPEN TO OPEN A:A - CLOSEDAABD - CLOSEDD - OPENIn the upper rack you can

Page 10 - What to do if

EN -7-How to load the racks4EFArrange crockery so that water does not collect in cavities, ensuring that the spray arms turn freely. Only use dishwash

Page 11

EN -8-678The dishwasher door must be closed and the water tap open.To pause the program (e.g. if you want to insert an item):- Open the door with caut

Page 12

EN -9-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault