EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the
cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push Start button and close
the door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained under normal conditions and with default options on. Data may vary depending on ambient conditions and used options. Differences of up to
20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test
and other tests, contact the following address: “contact@whirlpool.com”.
Power consumption in: Left-on mode: 1.08 W / Off-mode: 0.40 W.
RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.
A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product conditions.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
6th Sense
®
PowerClean
®
40°-70°C
Delay
Multizone
PowerClean
®
Antibacterial
rinse
Use for normal soiled dishes with dried-on food. Senses
the level of soiling on the dishes and adjusts the program
accordingly. When the sensor is detecting the soil level
an animation appears in the display and the cycle
duration is updated. The PowerClean
®
option is
activated automatically with this program. To deactivate,
press the PowerClean
®
button on the control panel.
X 7.5-13 0.95-1.45 85-175 Full
P2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. — 4.0 0.01 14-16 NO
P3
Fragile 40°C
Delay
Multizone
Light soiling, for example glasses and cups. X 10.5 0.85 105-114 Light
P4
Rapid 45°C
Delay
Multizone
Lightly soiled crockery, with no dried-on food. X 11.0 0.85 30-50 NO
P5
Eco
2)
50°C
Delay
Multizone
PowerClean
®
Antibacterial
rinse
Normally soiled crockery.
Standard program the most efficient in terms of its
combined energy and water consumption.
X 6.0 0.92 240 Full
P6
Daily 60°C
Delay
Multizone
Antibacterial
rinse
Normally soiled crockery. X 11.0 1.30 80-95 Full
P7
Silent 50°C
Delay
Multizone
Normally soiled crockery, gentle and
quiet thanks to the lower spray pressure.
X 10.0 1.20 290-299 Light
P8
Steam
Delay
Multizone
PowerClean
®
Antibacterial
rinse
Program including steam action dedicated for heavily
soiled crockery, pots and pans.
Soaking or hand pretreatment is no longer needed.
X 11.0 1.75 180-190 Full
5019 300 02721
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE
CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER
30 SECONDS IF NO CYCLE HAS STARTED.
OPERATION
INDICATOR
A LED light projected on
the floor indicates that
the dishwasher is
working.
RINSE AID INDICATOR
When lit (at the end of the cycle), the
rinse aid dispenser needs to be refilled.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
TABLET INDICATOR
See TABLET setting in
MULTIZONE description.
MULTIZONE
Allows you to choose the washing
zones. Press this button
(repeatedly) to select the wash
zones:
TABLET SETTING
This setting allows to optimize the
cycle performances according the
type of detergent used.
Push the MULTIZONE button for
3 seconds (until the indicator lights
up) if you are using the combined
detergents in tablet.
If you are using powder or gel
detergent, the Tablet indicator on
the control panel has to be off.
both racks
only upper rack
only lower rack
( - indicator lights)
POWERCLEAN
®
Thanks to the additional
power jets this option provides a
more intensive and powerful wash
in the lower rack, in the specific
area.
ANTIBACTERIAL RINSE
This function activates an
antibacterial rinse at the end of the
wash cycle, guaranteeing a further
reduction of bacteria. Press the
utton to activate or deactivate the
function.
This function can be used with the
programs indicated in the table of
programs. The dishwasher door
must be kept shut for the entire
duration of the program in order
to guarantee reduction of bacteria.
If the door is opened the indicator
lamp starts flashing.
DELAYED START
BUTTON
Push the button
(repeatedly) to
delay the start of
the program.
Adjustable from
1to 24 hours.
With each press of
the button, the
delayed start
indicator increases
by one hour and
after 24 restarts
from 0.
Then press the
START button.
The dishwasher will
start after the set
time.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time
(h:min).
With “Delayed start” selected it indicates the time
remaining until program start (h.00) - below 1h
(0:min).
If “Fx Ey” messages appears on the display, see page 6
- chapter “What to do if...”.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
(8 pages)
(8 pages)
(8 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals