Whirlpool ADG 8900 Instruction for Use Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
EN -5-
Wash cycle
Select program
6
7
8
Maintenance and care
Maintenance and care
Overview of programs
The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).
Choose program according to the attached table of programs (page 1).
Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.
For hygienic reasons it is recommended to run at least once per month a high-temperature cycle (e.g. Intensive 65). It will help to keep the appliance clean, fully functional and avoid odours.
Rectifying minor faults yourself...
After the program is completed appliance turns into Standby mode automatically. All indicator lamps switch off.
Exercise caution when opening the door: beware of hot steam.
Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
The dishwasher door must be closed and the water tap open.
To pause the program (e.g. if you want to insert an item):
- Open the door with caution (the program pauses) and insert the item/s,
(beware of HOT steam!).
- Press the button and close the door within 3 seconds (the program
resumes the cycle from where it was interrupted).
To Cancel the program on running:
- Open the door, press the button and
close the door.
- (Water drains for up to 1 minute then the
appliance switches off).
To change the program in progress:
- Open the door, press the button to cancel the running program and close
the door.
- (Water drains for up to 1 minute then the appliance switches off).
- Open the door and press any button except button to switch on the
appliance.
- Select a new program.
- Press the button and close the door within 3 seconds.
Switching off the appliance. Everything OK...
9
Filters
Check and
clean if
necessary
Unscrew
microfilter (1),
remove it (2)
and remove
fine sieve (3)...
Rinse under
running water...
Screw on microfilter NOTE MARK!
Insert
10
Unscrew
and remove
lower arm...
Spray arms
Remove
blockages/
deposits.
Clean spray
nozzles under
running water
(use toothpicks
if necessary)...
Insert and screw on upper and lower arms tightly.
Unscrew
and remove
upper arm...
Page view 4
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments