Whirlpool ADG 9340/3 Instruction for Use download pdf

-1-

Chart

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the indicator of the required programme lights

up (see “Table of programmes” below).

BUTTON

OFF

BUTTON

START BUTTON

The indicator lights up during operation, flashes when a fault occurs and goes off at

the end of the programme.

START BUTTON RESET FUNCTION

Press this button for at least 2 seconds; the selected programme and options are

cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be

cancelled by RESETTING. Detailed instructions are given in chapter “What to do if...”.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions

(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible

with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“[email protected]”.

Table of programmes

Detergent

Consumption

Programmes Loading instructions Litres kWh

Minutes

Quickwash 40°C

Lightly soiled crockery, with no dried-

on food.

* Use of tablets not

recommended.

10.0 0.65 30

Eco

50°C

Normally soiled crockery.

Energy-saving programme.

X 12.0 1.05 165

Intensive 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pots and pans.

X 14.0 1.55 155

5019 396 01766ADG 9340

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01766ADG 9340

GB -1-ChartPROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the indicator of the required programme lights up (see “Table of programmes”

Page 2 - First time use

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3

GB -3-Daily check ELSSELELSELS123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off th