Whirlpool ADL 448/2 Instruction for Use

Browse online or download Instruction for Use for Dishwashers Whirlpool ADL 448/2. Whirlpool ADL 448/2 Instruction for Use User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
GB
-1-
Chart
PROGRAMME SELECTION BUTTON
Press button “P” (repeatedly) until the indicator of the required programme lights
up (see “Table of programmes” below).
ON
BUTTON
OFF
BUTTON
START BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at
the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are
cancelled. Main failure displays (repeated flashing of the START indicator lamp) can
be cancelled by RESETTING. Detailed instructions are given in chapter “What to
do if...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of
the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information
on the EN/Standard loading comparison test and other tests, contact the following address: “nk_cu[email protected]”.
Table of programmes
Detergent
Consumption
P
Programmes Loading instructions Litres kWh
Minutes
1)
1
Pre-Wash cold
Crockery to be washed later. 5.0 0.02 10
2
Quickwash 40°C
Lightly soiled crockery, with no
dried-on food. * Use of tablets not
recommended.
X * 13.0 0.70 30
3
Bio
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X 15.0 1.05 165
4
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
X 17.0 1.65 145
5019 596 01516ADL 448
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE INSTALLATION
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Quick reference guide
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 596 01516ADL 448

GB -1-ChartPROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the indicator of the required programme lights up (see “Table of programmes”

Page 2 - First time use

GB -2-First time use578623SEL141091- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pane

Page 3 - Daily use

GB -3-Daily check123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt level indicat

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...Disconnect the mains plugIf, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the m

Comments to this Manuals

No comments