Whirlpool ADP 941/2 WH Instruction for Use download pdf (Page 6)

44

Close the dishwasher door and turn on

the water tap.

1.

Press the ON/OFF button to switch on the

dishwasher. Select the programme required

by

turning the programme selector knob

.

The corresponding indicator lamp will

illuminate.

If required,

select any additional functions.

2.

Press the

Start

button to start the selected

wash programme. The Start

indicator lamp

will illuminate. Once set, the programmed data

cannot be altered by turning the programme

selector knob or pressing the buttons.

Note:

Once the

Start

button has been pressed,

the dishwasher memorises all the programmes

selected. The selected programmes are also

saved in the event of power failure.

3.

To change the programme selected, press

the

Start

button for about 5 seconds until the

Start

indicator lamp switches off. Select a

new programme using the

programme

sector knob and press the

Start

button.

The

End

indicator lamp (if fitted) illuminates

briefly and the

Start i

ndicator lamp switches

off to indicate the end of the programme.

4.

Turn the programme selector knob

counter

clockwise to the “0” position to switch off the

dishwasher

(only after the

End

indicator lamp

has illuminated briefly or the

Start

indicator

lamp has switched off). All the indicator

lamps switch off.

Note:

If the dishwasher is switched off

during a wash programme, when switched

on again the dishwasher resumes the wash

cycle from where it was interrupted.

Open the door and unload first the lower rack

and then the upper one.

HOW TO USE THE DISHWASHER

1

2

3

4

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments