Whirlpool DSG 2631 DE Instruction for Use download pdf (Page 26)

Care and maintenance

Shutting off the water and electricity

supplies

• Turn offthe water tap after everywash cycle toavoid

leaks.

• Alwaysunplugtheappliancewhencleaningitandwhen

performing maintenance work.

Cleaning the dishwasher

• Theexternal surfaces of the machine and thecontrol

panel may be cleaned using a non-abrasive cloth which

has been dampened with water. Do not use solvents or

abrasive products.

• Anymarksontheinsideoftheappliancemayberemoved

using a cloth dampened with water and a little vinegar.

Preventing unpleasant odours

• Alwayskeepthedooroftheapplianceajarinorderto

avoid moisture from forming and being trapped inside

the machine.

• Cleanthesealsaroundthedooranddetergentdispensers

regularly using a damp sponge. This will avoid food

becoming trapped in the seals, which is the main cause

behind the formation of unpleasant odours.

Cleaning the sprayer arms

Food residue may become encrusted onto the sprayer arms

and block the holes used to spray the water. It is therefore

recommended that the arms are checked from time to time

and cleaned with a small non-metallic brush.

The two sprayer arms may both be removed.

To remove the upper sprayer

arm, rotate the locking ring in an

anti-clockwise direction.

The upper sprayer arm should

be replaced with the holes

facing upwards.

The lower sprayer arm can be

removed by pulling it upwards.

Cleaning the water inlet filter*

If the water hoses are new or have not been used for an

extended period of time, let the water run to make sure it is

clear and free of impurities before performing the necessary

connections. If this precaution is not taken, the water inlet

could become blocked and damage the dishwasher.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.

- Unscrew the end of the water inlet hose, remove the filter

and clean it carefully under running water.

- Replace the filter and screw the water hose back into

position.

Cleaning the filters

The filter assembly consists of three filters which remove

food residues from the washing water and then recirculate

the water. They should be cleaned if you wish to achieve the

best results in every wash.

Clean the filters regularly.

The dishwasher should not be used without filters, or if

the filter is loose.

• After several washes,check the filterassembly and if

necessary clean it thoroughly under running water, using

a non-metallic brush and following the instructions below:

1. Turn the cylindrical filter C in an anti-clockwise direction

andpullitout(fig.1).

2. Remove the cup filter B by exerting a slight pressure on

thesideflaps(fig.2).

3. Slide out the stainless steel plate filter A (fig. 3).

4. Inspect the trap and remove any food residue. NEVER

REMOVE the wash cycle pump

(black detail) (fig. 4).

After cleaning the filters, replace the filter assembly and fix

it in position correctly; this is essential for maintaining the

efficient operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnecttheappliancefromtheelectricitysupplyand

shut off the water tap.

• Leavethedooroftheapplianceajar.

•Whenyoureturn,runawashcyclewhenthedishwasher

is empty.

* Only available in selected models.

1 ... 25 26 27 28

Comments to this Manuals

No comments

Whirlpool DSG 2631 DE Instruction for Use Page 26

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool DSG 2631 DE