Whirlpool DU7600XS Specifications download pdf (Page 12)

Common dishwashing problems

PROBLEM CAUSED BY

SOLUTION

Spottlng and

fllmlng

(hard water film)

Small partlcles

deposlted on

Items

Dishes not dry

Black marks on

dishes

Chlpplng or

breaklng

glassware

Hard water

Water IS not

hot enough

Not enough

detergent, or

Improper detergent

“0ld”detergent

Improper loading

No rinse aid

AIR DRY Setting used

Spray arm or arms not

rotating freely

“Old” detergent

Not enough

detergent, or

Improper detergent

Water IS not hot

enough

Water pressure may

be low, dishwasher IS

not filling properly

Water is not hot

enough

Improper loading

No rtnse aid

AIR DRY Setting used

Aluminum utensils

rubbing against items

during washing

Improper loading

Fill detergent dispensers to capocrty Use drshwasher de-

tergent wrth hrghest avorlable phosphorus content May

be necessary to install water softener

To remove spots and film, try a vinegar rinse

1. Wash and rinse load as usual. Use AIR DRY

2. Remove all metal items

3. Put 2 cups (500 ml) white vinegar tn a container on the

bottom rack

4 Run drshwosherthrough a complete washing cycle.

Water temperature should be at least 140 F (60 C). Set

water heater thermostat to a higher settrng Run water at

sink until hot before starting and/or use HI-TEMP WASH

Option

Use more dishwasher detergent. Use detergent with hrgh-

est available phosphorus content especrolly with hard

water.

Use only fresh dishwasher detergent. Store tightly closed

container, in cool, dry place. Discard old detergent. Do not

fill dispensers until ready to start dishwasher.

Make sure dishes and glassware are loaded so spray

reaches all surfaces and items drain properly. Do not ov-

erload. Do not nest Items.

Make sure large items do not block spray from reochrng

detergent dispensers.

Does the rinse aid dispenser need filling7 See instructions

on page 7

Drying without heat may result in some spotting of glasses

and silver

Check spray arms to make sure they turn freely after load-

rng. Be sure a utensil has not prevented theirturning.

Use only fresh dishwasher detergent. Store tightly closed

container, in cool, dry place. Discard old detergent. Do not

fill dispensers until ready to start dishwasher

Use more dishwasher detergent Use detergent with high-

est avarlable phosphorus content.. especrally with hard

water

Water temperature should be at least 140 F (60 C). Set

water heater thermostat to a hrgher setting Run water at

sink until hot before starting and/‘or use HI-TEMP WASH

Option

If water pressure is low, do not use water for other purposes

while dishwasher IS running [to assure correct fills)

Water temperature should be at least 140-F (60FC). Set

water heater thermostat to a higher settrng. Run water at

sink until hot before startrna and/or use HI-TEMP WASH

Option

Make sure dishes and glassware are loaded so spray

reaches all surfaces and items drain properly Do not ov-

erload. Do not nest items

Fill

rinse aid dispenser

Allow more time when using AIR DRY Option, or use HEAT

DRY Plastic Items may need towel drying.

Use care in loadlng aluminum utensils, especially any

llghtwelght loll container. Place so they do not touch

dlshes. Remove black marks with plastic scouring pad

and a mild abrasive cleanser

Do not overload. toad glasses In the top rack only Load

between prongs, not over them Glasses loaded over

prongs

will

not be supported and may chip or break

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Whirlpool DU7600XS Specifications Page 12

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool DU7600XS