Whirlpool GSXA 7525/1 Instruction for Use download pdf

5019 496 01117

GSXA 7525

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.

different loads, options, different sensor settings (only with sensor programmes), different water supply temperatures, as well

as water hardness and power supply voltage.

2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories:

for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

1. OVERVIEW

On button

Off button

Delayed start button

Press the button repeatedly to delay

the start of the programme by 3, 6

or 9 hours. Then press the START

button. The dishwasher will start at

the set time.

Detergent setting upon initial use and when using a different

type of detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the

display.

3. Using the START button, select the desired detergent:

“3h” = 2in1, “6h” = 3in1, “9h” = other combined action

detergents (In this way the rinse aid and/or salt indicator is

deactivated). All 3 LEDs light up = Powder detergent

(factory setting).

4. Switch the appliance off and then switch it on again. The

selected detergent type will be indicated on the display for

approx. 3 seconds by the corresponding LEDs.

Programme selection button

Press the button repeatedly until the desired

programme indicator lights up.

START button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the

end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the

selected programme and options are cancelled.

Main failure displays (repeated flashing of the

START indicator lamp) can be cancelled by

RESETTING. Detailed instructions are given in

chapter 5 “What to do, if...”.

The acoustic signal continues to sound as long as

the error persists.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or

salt need to be added.

Add just before starting a wash programme.

Table 1.1.

Programme chart

Detergent

dispenser

Consumption

Programmes

Available

options

Loading instructions

large small Litres kWh Minutes

Auto Sensor 50-65°C

Recommended programme for

routine washes, with dried-on

food (e.g. EN 50242).

X X 11-16 1.10-1.50 100-130 ±

Pre-Rinse cold

Crockery to be washed later. — — 4.0 0.03 14 ±

Quickwash 40°C

Lightly soiled crockery, with no

dried-on food.

X — 11.0 0.80 30 ±

Bio Normal

50°C

Normally soiled crockery.

Energy saving programme.

X X 12.0 1.05 165 ±

Intensive 70°C

Recommended programme for

heavily soiled crockery,

especially suitable for pans and

saucepans.

X X 14.0 1.55 155 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

5019 496 011171GBGSXA 7525Before using the dishwasher, read the installation and maintenance instructions carefully!1) Programme data obtained in conf

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on the modelLong-handled utensils (kitchen knives) must be arranged with the s

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l