Whirlpool Ikea IUD8000R Troubleshooting Guide download pdf (Page 12)

Lock

Use the lock to prevent unintended use of the dishwasher. You

can also use the lock feature to prevent unintended cycle or

option changes during a cycle.

O CONTROL LOCK

PRESS & HOLD

When the lock is lit, all buttons are disabled.

NOTES:

• The dishwasher door can be opened while the controls are

locked.

• You can turn on the lock while the dishwasher is running. If

you open the door, unlock the controls and press START/

RESUME to restart. You can lock controls again, if desired.

To turn on the lock

Press and hold HEATED DRY for 4 seconds. The lock glows.

If you press any pad while your dishwasher is locked, the light

flashes 3 times and the selection is ignored.

To turn off the lock

Press and hold HEATED DRY for 4 seconds. The light turns off.

Delay start

Select this option to run your dishwasher at a later time or during

off-peak hours. You can add items to the load anytime during the

delay countdown. After adding items, close the door firmly until it

latches. The delay countdown will not continue if the door is not

latched. Press START/RESUME. If the door is unlatched, the

Start/Resume indicator flashes. The delay countdown stops until

you latch the door and press START/RESUME.

To delay the start

1. Press DELAY for a 4-hour delay. The number above or to the

left of the 4 Hour Delay pad glows.

2. Select a wash cycle and option or skip to Step 3 to use the

cycle and options selected for last cycle.

3. Press START/RESUME. (The door must be closed.) The delay

countdown starts, and the cycle will begin after 4 hours.

NOTES:

• To cancel the delay and cycle, press CANCEL/DRAIN.

• To cancel the delay and start the cycle, press START/

RESUME.

Follow the progress of your dishwasher with the Cycle Status

indicators.

WASHING DRYING CLEAN SANITIZED

NOTE: Your model may have some or all of the indicators shown

above.

Clean

Clean glows when a cycle is finished. The light turns off when you

open and close the door or press any button.

Sanitized

If you select Sanitize Rinse, Sanitized glows when the Sanitize

Rinse option is finished. If your dishwasher did not properly

sanitize your dishes, the light flashes at the end of the cycle. This

can happen if the cycle is interrupted, or the water could not be

heated to the required temperature. The light goes off when you

open and close the door or press any button.

During drying, you can see steam escaping through the vent at

the upper left corner of the door. This is normal as the heat dries

your dishes.

IMPORTANT: The vapor is hot. Do not touch the vent

during drying.

The overfill protection float (in the front right corner of the

dishwasher tub) keeps the dishwasher from overfilling. It must be

in place for the dishwasher to operate.

Check under the float for objects that may keep the protector

from moving up or down.

1 ... 11 12 13 ... 36

Comments to this Manuals

No comments

Whirlpool Ikea IUD8000R Troubleshooting Guide Page 12

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool Ikea IUD8000R