Whirlpool KUDS02FSPA User Manual download pdf (Page 8)

Option 2: Power supply cord method:

NOTE: A mating, three prong, ground-type wall receptacle is

required in a cabinet next to the dishwasher opening.

1. Drill a 1-1/2”

(3.8 cm) hole in

the cabinet rear

or side. Preferred

and optional

locations are

shown.

2. Wood cabinet:

Sand hole until

smooth.

Metal cabinet: Cover hole with grommet (Part No.

302797) included with power supply cord kit.

Install the water line

Helpful Tip: Routing the water line through the left side

of cabinet opening will make water connection easier.

1. Drill a minimum 1/2” (1.3 cm) hole in the cabinet side,

rear or floor. Preferred and optional locations are shown.

2. Measure overall length

of copper tubing

required.

3. Attach copper tubing

to the water line with a

manual shutoff valve.

4. Slowly feed copper

tubing through hole in

cabinet. Copper tubing will bend and kink easily, so be

gentle. The copper tubing should be far enough into the

cabinet opening to connect it to dishwasher inlet on the

front left of the dishwasher.

5. Turn water shutoff valve to “ON” position. Flush water

into a shallow pan to get rid of particles that may clog

the inlet valve.

6. Turn shutoff valve to “OFF” position.

Option 1: Waste disposer – with air gap:

1. Remove the disposer knockout plug. Cut end of drain

hose if needed (do not cut ribbed section).

2. Attach drain hose to air gap with large spring-type

clamp. If the drain hose was cut, use a 1-1/2" to 2"

(3.8 to 5 cm) screw-type clamp*.

3. Use a rubber hose connector* with spring or screw-type

clamps* to connect air gap to disposer inlet.

This connection must be before the drain trap and at

least 20" (50.8 cm) above the floor where dishwasher will

be installed.

4. Insert drain hose through

hole cut in cabinet to the

front center of opening

where drain connection

will be made.

* Parts available from local plumbing

supply stores

copper

tubing

drain

hose

large

spring-type

clamp

air gap

rubber hose

connector

disposer

inlet

drain trap

drain hose –

cut here if needed

spring or

screw-type

clamps

preferred

locations

optional

locations

optional

locations

preferred

locations

Install the drain hose

IMPORTANT: Always use a new drain hose.

1. Drill a 1-1/2” (3.8 cm)

diameter hole in cabinet

wall or floor on the side

of the opening closest

to the sink.

2. Connect drain hose to

waste tee or waste disposer using one of the following

methods:

• Option 1, Waste disposer – with air gap

• Option 2, No waste disposer – with air gap

• Option 3, Waste disposer – no air gap*

• Option 4, No waste disposer – no air gap*

*an air gap is recommended

Helpful Tip:To reduce the vibration of the hose, keep the

hose away from the floor and the edge of the hole where

it passes through the cabinet.

drain hose

1 2 3 4 5 6 7 8 9 ... 44

Comments to this Manuals

No comments

Whirlpool KUDS02FSPA User Manual Page 8

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool KUDS02FSPA

Relacionado con productos y manuales para Radio de coche Pioneer DEH-5000UB