Whirlpool WDT710PAHZ Manual and User Guide download pdf (Page 7)

STEP 3

Add Rinse Aid

■ Your dishwasher is designed to use rinse aid for good drying

performance. Without rinse aid, your dishes and dishwasher

interior will have excessive moisture. The Heat Dry option will

not perform as well without rinse aid.

■ Rinse aid keeps water from forming droplets that

can dry as spots or streaks. They also improve drying

by allowing water to drainoff of the dishes after the

ﬁnal rinse.

■ Check the rinse aid indicator. Add rinse aid

when indicator drops to “Add” level.

■ To add rinse aid, turn the dispenser cap 1/4 turn

counterclockwise and lift off. Pour rinse aid into

the opening until the indicator level is at “Full.”

Replace the dispenser cap and turn to “Lock.”

Make sure cap is fully locked.Close the

dispenser by pushing down gently on the lid.

NOTE: For most water conditions, the factory

setting will give good results.

■ Check water hardness level to ensure there are no rings or

spots on your dishware before adding rinse aid or adjusting

the factory setting.

■ If you have hard water or notice rings or spots, try

a higher setting.

Turn the arrow adjuster inside the

dispenser by either using your ﬁngers

or inserting a ﬂat-blade screwdriver into

the center of the arrow and turning.

STEP 4

Select a Cycle

Efﬁcient dishwashers run longer to save water and energy, just

as driving a car slower saves gas. Cycle times may increase or

decrease, depending on selections. Estimated cycle times after

calibration are listed in the “Cycle and Option Descriptions”

chart in the following section. Select the desired cycle by

pressing the Cycles keypad. Each time you press the Cycles

keypad, it will advance to the next available cycle.

Select Options

See the “Cycle and Option Descriptions” chart in the

following section.

You can customize the cycles by selecting the options

desired and pressing the Start/Resume keypad.

STEP 5

Start or Resume a Cycle

■ If needed, run hot water at the sink nearest your dishwasher

until the water is hot. Turn off water.

■ For best dishwashing results, water should be 120ºF (49ºC)

as it enters the dishwasher.

■ Select the wash cycle and options desired.

To repeat the same cycle and options used

previously, press the START/RESUME

keypad twice. Within 4 seconds of pressing

Start/Resume, you must ﬁrmly push the

door closed. If the door is not closed within

4 seconds, the Start/Resume LED will ﬂash

and the cycle will not start.

■ You can add an item at the beginning of the cycle. Open the

door slowly and add the item. Press the START/RESUME

keypad and close the door ﬁrmly within 4 seconds. If the

door has been open more than 4 seconds, the LED will ﬂash

and the dishwasher will not resume unless you press Start/

Resume again.

IMPORTANT: If the door has been opened after starting a cycle

(even during the Delay Hours option), Start/Resume must be

pressed again.

Full

Add

Lock

max

fill

max

fill

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comments to this Manuals

No comments

Whirlpool WDT710PAHZ Manual and User Guide Page 7

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool WDT710PAHZ