Whirlpool W10115229C-SP User Manual

1W10115228C W10115229C-SPTable of Contents DRYER SAFETY ...2INSTALLATION REQUIREMENTS ...

10Venting RequirementsWARNING: To reduce the risk of re, this dryer MUST BE EXHAUSTED OUTDOORS.IMPORTANT: Observe all governing codes and ordinances.

11Plan Vent SystemRecommended exhaust installationsTypical installations vent the dryer from the rear of the dryer. Other installations are possible.B

12Vent System ChartNumber of 90° turns or elbowsType of ventBox/louvered hoodsAngled hoods14320Rigid metalRigid metalRigid metalRigid metalRigid met

13ABCDPlan pipe tting connection 2.A combination of pipe ttings must be used to connect dryer to existing gas line. A recommended connection is show

14Level DryerLevel dryer1. Not Level LEVEL Not LevelCheck levelness of dryer from side to side. Repeat from fro

15Place towel on dryer1.Place towel on top of dryer to avoid damaging the surface.Remove bottom screws2.Open dryer door. Remove bottom screws from dry

1629" Super Wide Side-Swing DoorPlace towel on top of dryer to avoid damaging the surface.Place towel on dryer1.Remove bottom screws2.Open dryer

17Flip door over7.Flip door over so handle side is down. Attach door hinges8.Reattach door hinges to dryer door so that the larger hole is at the bott

1827" Wide Model Side-Swing DoorRemove door strike plug. Insert the door strike removed in Step 9 into hole and secure with screw. Insert door st

19Rotate outer door6.Take outer door and rotate it 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors

2DRYER SAFETY

20Check door strike alignment11.Close door and check that door strike aligns with door catch. If it is needed, slide door catch left or right within s

21Rotate outer door8.Take outer door and rotate it 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors

22Check door strike alignment14.Close door and check that door strike aligns with door catch. If it is needed, slide door catch left or right within s

3

4Tools and PartsGather the required tools and parts before starting installation.Tools needed for all installations: LevelTape measurePliersFlat-blade

5Parts package is located in dryer drum. Check that all parts are included.Parts needed:Check local codes. Check existing electrical supply and venti

629" Wide Models Dryer DimensionsA. Large opening side-swing doorB. Large opening side-swing doorC. Wide opening side-swing doorD. Wide opening h

7GROUNDING INSTRUCTIONSSAVE THESE INSTRUCTIONS For a grounded, cord-connected dryer: This dryer must be grounded. In the event of malfunction or bre

8GAS DRYER POWER HOOKUPGas Supply RequirementsGas typeNatural gas:This dryer is equipped for use with Natural Gas. It is design-certied by CSA Intern

9†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.Elevations above 10,000 ft. (3,048 m): When installed above 10,000 ft. (3