Whirlpool WHD560CHW Use and Care Manual download pdf (Page 11)

CLEANING THE LINT SCREEN

Clean lint screen after every load

The lint screen is located in the door opening of the dryer.

A screen blocked by lint can increase drying time.

To clean:

1. Pull the lint screen straight up and out. Press tab down

and open lint screen. Roll lint off the screen with your

fingers.

2. Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged,

blocked, or missing. Doing so can cause overheating and

damage to both the dryer and fabrics.

As needed cleaning

Laundry detergent and fabric softener residue can build up

on the lint screen. This buildup can cause longer drying times

for your clothes, or cause the dryer to stop before your load is

completely dry. The screen is probably clogged if lint falls off

while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months,

or more frequently, if it becomes clogged due to a residue

buildup.

To wash lint screen:

1. Roll lint off the screen with

your fingers.

2. Wet both sides of lint screen

with hot water.

3. Wet a nylon brush with hot water

and liquid detergent. Scrub lint

screen with the brush to remove

residue buildup.

4. Rinse screen with hot water.

5. Thoroughly dry lint screen with

a clean towel. Reinstall screen

in dryer or lint filter.

CLEANING THE HybridCare™ FILTER AND

FILTER LINT SCREEN

Clean HybridCare™ filter after every 5 loads

The filter is located in bottom corner of dryer. The control

panel has an indicator light to remind you to clean the

HybridCare™ filter.

1. Open the bottom filter door. Lift handle up and pull

out filter. Set filter on the dryer and pull out lint screen

located at the back of the filter. Remove lint off the

screen with your fingers.

NOTE: If lint still remains on

screen then wet both sides

with hot water. If necessary,

wet a nylon brush with hot

water and liquid detergent.

Scrub lint screen with the

brush to remove residue

buildup. Rinse screen with

hot water.

2. Clean the filter housing

and mesh inside with a

damp cloth, household

vacuum cleaner, or soft

brush. Clean the screen

at the back of the filter

cabinet once a month.

3. Put lint screen back into

filter and put filter back in

dryer cabinet. Dryer will

not operate without filter

and make sure the handle

is downward to lock in

place. LF will display if not

properly seated.

IMPORTANT:

Do not run the dryer with the filter loose, damaged,

blocked, or missing. Doing so can cause overheating

and damage to both the dryer and fabrics.

1 ... 10 11 12 ... 37

Comments to this Manuals

No comments

Whirlpool WHD560CHW Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool WHD560CHW