Install properly...
1. Allow ^2 inch (1.25 cm) space on each side and
af the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer...
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
LEVELLING SCREW
RAISE
1. Remove base grille (see page 7).
2. To raise front, turn the screw in the direction
shown.
3. To lower front, turn the screw in the direction
shown.
4. Check with level.
5. Replace base grille (see page 7).
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN
STRUCTIONS LABELS INSIDE YOUR REFRIGER
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refriger
ator before using it.
See cleaning instruc
tions on page 8 '
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
Comments to this Manuals