Changing the light bulbs...
WARNING: Before removing a light bulb, either unplug the refrigerator or disconnect the
eiectricity ieading to the refrigerator at the main power suppiy. Shock and injury can
occur if electricity remains connected.
1. Reach behind the control console to find bulbs.
2. Remove bulb.
3. Replace with a 40-watt appliance bulb.
Removing the base grille.
To remove the grille:
1. Open the door.
2. Pull grille outwards as shown.
3. Do not remove Tech sheet fastened behind
grille.
Ice cube trays...
(Model ET20GK)
If cubes are not used, they may shrink. The mov
ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
Automatic ice maker...
If you have Model ET20GM and have the auto
matic ice maker accessory, or if you have Model
ET20GK and plan to add one later (Part No.
ECKMF-83), there are a few things you will want to
know:
• The ON/OFF lever Is a wire signal arm.
Down...for making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON
NECTED TO THE WATER SUPPLY.
• The dial or lever on the side of the ice maker
changes the size of the cubes.
• Shake the bin occasionally to keep cubes sepa
rated, and to obtain increased storage ca pacify.
• It is normal for ice crescents to be attached by a
corner. They will break apart easily.
• You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
MHAL CLIPS
^ SUPPORT TABS
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door.
To remove ice:
1. Hold tray at both ends.
2. Slightly twist.
LOWER
SIGNAL
ARM TO 1
START IT
RAISE
SIGNAL
ARM TO
STOP ICE
• The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
• Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
• It ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control to
ward a higher number. Wait a day and, if neces
sary, turn the Freezer Control toward A,
Comments to this Manuals