Whirlpool ED22DQ Specifications download pdf (Page 16)

The water dispenser

Chilled water comes from a tank behind the meat

drawer. It holds approximately 11/2quarts (1.5 L).

When the refrigerator is first hooked up, press the

water dispenser bar with a glass or jar until you draw

and discard two or three quarts (1.9 to 2.8 L). The

water you draw and discard rinses the tank and pipes.

Allow several hours to chill a new tankful.

NOTE: The small tray beneath the dispenser is de-

signed to evaporate small spills. There is no drain in

this tray. Do not pour water into it.

To dispense water:

1. Press a sturdy glass against the water

dispenser bar,

2, Remove the glass to stop dispensing.

NOTE: Dispense enough water every week to maintain

a fresh supply.

The dispenser light

To turn on night light, slide dispenser LIGHT switch

to the left. See page 21 for directions for changing the

dispenser light bulb.

ON OFF

WATER

Solving common ice dispenser problems

PROBLEM POSSIBLE CAUSE/SOLUTION

Ice dispenser will

not work

• Freezer door is open.

• Ice bin not properly installed. Make sure the bin is pushed in all the way.

• Wrong ice in bin. Only use crescents from the ice maker. Shake the bin

occasionally to separate cubes and increase storage room.

• Dispenser not used for extended periods of time, causing ice cubes to melt

together. Dump old ice and make a new supply.

Ice dispenser stops

working

• Ice dispenser bar held in too long. Wait about three minutes for dispenser

motor to reset.

• Large amounts of ice should be taken from the bin, not through the dispenser.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 93 94

No comments

Whirlpool ED22DQ Specifications Page 16