Whirlpool EDI9SK User Manual download pdf (Page 4)

Install properly...

1. Allow % inch (1.25 cm] space on each side and

at the top of the refrigerator for ease of

installation.

2. If the refrigerator is to be against a wall, you

might want to leave extra space so the door

can be opened wider.

3. The refrigerator back can be flush agarnst the

wall.

Level refrigerator-freezer.. .

RAISE

1. Remove base grille (see page 7).

2. To raise front, turn legs in direction shown

3. To lower front, turn legs in direction shown

4. Check with level.

5. Replace base grille [see page 7).

Remove sales labels...

Remove the Consumer Buy Guide label, tape

and any inside labels before using the re-

frigerator. To remove any remaining glue:

1. Rub briskly with thumb to make a ball then

remove

2. Soak area with liquid hand dishwashing

detergent before removing glue as described

In step 1.

DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the

material.

NOTE: DO NOT REMOVE ANY PERMANENT IN-

STRUCTIONS LABELS INSIDE YOUR REFRIGER-

ATOR.

Do not remove the Tech sheet fastened under

the refrigerator at the front.

Clean it...

Clean your refriger-

ator before using it.

See cleaning instruc-

tions on page 8

Plug it in...

3-PRONG

TYPE WALI

GROUNDING

. RECEPTACLE \

REFRIGERATOR

J-PRONG -

POWER CORD

GROUNDING PLUG

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is

required. It is recommended that a separate cir-

cuit serving only this appliance be provided.

Do not use an extension cord. Use a recepta-

cle which cannot be turned off with a switch or

pull chain. See individual electrical requirements

and grounding instruction sheet in your literature

package

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Whirlpool EDI9SK User Manual Page 4

Comments to this Manuals

Related products and manuals for Fridges Whirlpool EDI9SK