Whirlpool ET22ZM User Manual download pdf (Page 7)

Changing the light bulb...

WARNING: Before removing the light shield for

cleaning or for replacing the bulb,

either unplug refrigerator or discon-

nect electricity leading to re-

frigerator at the main power supply.

Shock and injury can occur if elec-

tricity remains connected.

Push in the Center;

Pull Down.

Automatic ice maket..

The automatic Ice maker IS in the freezer section of

your refrigerator. The following things should be known

for proper Ice maker use

The ON OFF lever IS a wire signal arrr

Down for making ice automat~cal’i

Up to shut off the ice maker

Shake the bin occasionally to keep &oes sey;c

rated, and to obtain Increased storage capac~+r

Lower Signal

Raise Signal

Arm to Start It

Arm to Stop Ice Maker

normal for Ice c’escents tc be attached Lr

-J

corner They will break apart easllv

You will hear water ruqnlng w?en ice maker i

working You’ll hear Ice fall into: ti‘e tl ‘I ?\I~I t -.I

Removing the base grille...

Push lightly on the top center of the light shield until

the notched iab unhooks from the control panel

Pull down on the shield until the tab clears the con-

trol panel

LIH the back hooks oui of their slots

Replace with a 40-watt appliance bulb

Replace light shteld in reverse order

these sounds bother you

The ice maker will not operate until the freezer IS

cold enough to make ice This can take overnight

Because of new plumbing connectIons, the first

Ice may be &colored or off-flavored Discard the

first few batches of Ice

If Ice IS not being made fasi enough and more ice

IS needed, turn the Temperature Control toward a

higher number. Wait a day and, If necessary, turn

the Air Control toward A

If you remove the Ice bin, raise the signal arm to

snu+ off the ice maker When you return the bin.

push It all the way in and lower ihe arm to the ON

position

If cubes are stored too long, they may develop an

off-flavor like stale water Throw them away They

WIII oe replaced Cubes In the Ice bin can also

become smaller by evaporation

Good water quality IS important for good Ice quality

I+ IS not recommended that the Ice maker be con-

nected to a softened water supply. Water softener

chemicals such as salt from a malfunct~onlng soft-

ener can damage the Ice maker mold and lead to

poor quality ice If a softened water supply cannot

be avoided, then It IS important that the water soft-

ener be well maIntaIned and operating properly

To replace:

? Liqe up grille support tabs with metal clips

L Pull grille outwards as shown

? Push, firmly to snap tnto place

3 Do not remove Tech sheet

fas’ened behlno gril c?

3 Close the doors

Support labs

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Whirlpool ET22ZM User Manual Page 7

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ET22ZM