Whirlpool EVISOF Specifications Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Removing the bottom trivet . . .
To remove:
1. Lift front of trivet out of supports.
2. Pull out.
Lift the Front,
Then Pull Out.
To replace:
1. Position bock of trivet on the rear wall supports
2. Lower front into place.
The key eject
lock...
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal light is not glowing,
immediately check:
l
for power interruption,
l
For on unplugged power cord,
l
for Q burned out signal light.
Energy saving tips...
You can help your freezer use less electrlclty
l
Set Temperature Control to provide temperatures
l
Check door gasket and level freezer to assure a
around 0°F ( ~ 17.8 “C). There is no need to store
good door seal
foods below 0°F
l
Clean the condenser COIIS regularly
l
Keep door openings to a mlnlmum Remove several
e items at one time Keep cor;tents organized to ellrnl-
nate searching
l
FIII to capaclty Follow recommended procedures
for freezing foods See pages 0 and 9
6
l
Keep door locked to ensure door closure
l
Do not let frost build up to more than ::: Inch (6 mm]
thick Efficiency
IS
reduced
l
Keep Power Saving Control on OFF when humldlty
IS
low
can help reduce the hazard of child
entrapment
To lock or unlock the freezer you must hold the
key In the lock while turning. The lock IS spring
loaded so the key cannot be left in the lock.
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light:
1, Unplug power cord from outlet.
2. Open the freezer door.
3. Unplug burned out light and replace with one of
some wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer,
Part No. 1103680
4. Close freezer door and plug power cord into outlet.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments