Whirlpool GARF06XXMG00 User Manual download pdf (Page 7)

4. Place the mat in the top tray.

NOTE: Tuck the mat behind the mat pegs to keep the vent holes

clear as shown.

Install the Handle

1. Untape and open the door.

2. Install the handle using (4) #8 x ¹⁄₂ in. countersink handle screws

as shown.

Install the Can Rack

NOTE: Maximum load is (35) 12 oz. cans.

1. Slide the 4 can rack posts between the notches on the door liner.

2. Check to make sure the rack is firmly in place.

Refrigerator Shelves

To install shelves:

1. Determine the shelf placement inside the refrigerator.

2. Place the shelf into the desired shelf glide and slide it toward the

back fully past the shelf stop.

To remove shelves:

1. Lift the shelf up and over the shelf stop in the back.

2. Pull it toward you until it comes out of the shelf glide.

Normal Sounds

Your new refrigerator may make sounds that your old one didn’t

make. Because the sounds are new to you, you might be concerned

about them. Most of the new sounds are normal. Hard surfaces, such

as the floor, walls, and cabinets, can make the sounds seem louder.

The following describes the kinds of sounds and what may be

making them.

■ Your refrigerator is designed to run more efficiently to keep your

food items at the desired temperatures and to minimize energy

usage. The high efficiency compressor and fans may cause your

refrigerator to run longer than your old one. You may also hear a

pulsating or high-pitched sound from the compressor or fans

adjusting to optimize performance.

■ Rattling noises may come from the flow of refrigerant or items

stored inside the refrigerator.

■ As each cycle ends, you may hear a gurgling sound due to the

refrigerant flowing in your refrigerator.

■ You may hear water running into the drain pan during the defrost

cycle.

■ You may hear clicking sounds when the refrigerator starts or

stops running.

REFRIGERATOR USE

Using the Control

For your convenience, your refrigerator control is preset at the

factory. When you first install your refrigerator, make sure that the

control is still preset to the mid-setting 5 as shown.

To turn your refrigerator off, turn the refrigerator control to the off

position as shown.

NOTE: Your product will not cool when the refrigerator control is in

the off position.

Adjusting Controls

The mid-setting indicated in the previous section should be correct

for normal usage. The control is set correctly when beverages are as

cold as you like.

If you need to adjust the temperature, wait at least 24 hours between

adjustments and then recheck the temperature.

To make the refrigerator colder, adjust the control to the next higher

setting. To make the refrigerator less cold, adjust the control to the

next lower setting.

1. Mat pegs

2. Vent holes

1. Handle screws

1. Can rack posts

1. Off position

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Whirlpool GARF06XXMG00 User Manual Page 7

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GARF06XXMG00