Whirlpool GB2SHKXMQ00 User Manual download pdf (Page 6)

6. Fasten shutoff valve to cold water pipe with pipe clamp. Be

sure outlet end is solidly in the ¹⁄₄" drilled hole in the water

pipe and that rubber washer is under the pipe clamp. Tighten

packing nut. Tighten the pipe clamp screws carefully and

evenly so rubber washer makes a watertight seal. Do not

overtighten or you may crush the copper tubing, especially if

soft (coiled) copper tubing is used. Now you are ready to

connect the copper tubing.

7. Slip compression sleeve and compression nut on copper

tubing as shown. Insert end of tubing into outlet end squarely

as far as it will go. Screw compression nut onto outlet end

with adjustable wrench. Do not overtighten.

8. Place the free end of the tubing into a bucket or sink. Turn ON

main water supply and flush out tubing until water is clear.

Turn OFF shutoff valve on the water pipe. Check for leaks.

Coil copper tubing.

Connect to Refrigerator

1. Remove plastic cap from water valve inlet port. Attach the

copper tube to the valve inlet using a compression nut and

sleeve as shown. Tighten the compression nut. Do not

overtighten. Confirm copper tubing is secure by pulling on

copper tubing.

2. Create a service loop using extreme care to avoid kinks.

Secure copper tubing to refrigerator cabinet with a “P”

clamp.

3. Turn on water supply to refrigerator and check for leaks.

Correct any leaks.

4. Plug in refrigerator or reconnect power.

5. Push refrigerator into opening.

Base Grille

Remove Base Grille

1. Open the freezer door.

2. Grasp the grille with both hands.

3. Pull up on the bottom and tilt it toward you.

4. Pull down to release the top of grille.

Replace the Base Grille

1. Open the freezer door.

2. See markings on inside of base grille for proper placement.

3. Snap the top of grille into place first.

4. Press down and in on the bottom of the grille until it snaps

into place.

Refrigerator Doors

Install and Remove Handle

Graphics are included later in this section.

1. Place handle on door as shown.

2. Using a Phillips screwdriver, attach handle to door with

handle screws.

3. Place the trim pieces on the upper and lower handle ends as

shown.

4. Apply firm pressure with your hand on the face of the trim.

Slide the top trim down and bottom trim up toward the

handle.

5. Using a Phillips screwdriver, attach the freezer handle to the

freezer door with the two screws provided.

6. To remove handles, reverse directions.

A. Copper Tubing

B. “P” Clamp

C. Compression nut

D. Compression Sleeve

E. Water Valve Inlet Port

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Whirlpool GB2SHKXMQ00 User Manual Page 6

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GB2SHKXMQ00