Whirlpool MKV 1118-1 Instruction for Use download pdf (Page 8)

INSTALLATION

Before installation, make sure that

the tubes on the rear of the

refrigerator have not been bent in

transit. If the tubes touch the

refrigerator or the wall, the

refrigerator will be irritatingly noisy

during operation.

If necessary, bend them carefully to

restore the correct clearance.The

Mini-kitchen must be installed in a

fixed and plumb upright position.

Any unevenness of the floor can be

accommodated by adjusting the feet.

Warm air must be free to escape

unobstructed at the rear of the

refrigerator so as not to affect

operation (and not to cause

increased electrical power

consumption). Accordingly, the

ventilation slots near the hotplates

must not be covered.

The machine is approved only for

installation against a wall. No free-

standing installation with back far

from wall is allowed, neither built-in

installation in a closed cabinet.

Only items of furniture may be

placed adjacently on either side.

Note: To align the height of the

doors, adjust the front feet.

To install an extractor hood...

Observe the minimum distance from

the hotplates! Minimum distance

between electric hotplates and

lower edge of extractor hood:

650mm. For reasons of safety this

distance must absolutely be

maintained!

501930001563_en-GB_val2CMP.fm Page 8 Saturday, October 12, 2013 4:09 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Whirlpool MKV 1118-1 Instruction for Use Page 8