Whirlpool WRS571CIHW Owner's Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Style 2
1. Unplug refrigerator or disconnect power.
2. Turn OFF main water supply. Turn ON nearest faucet long
enough to clear line of water.
3. Locate a
¹⁄₂" (1.27 cm) to 1¹⁄₄" (3.18 cm) vertical cold water
pipe near the refrigerator.
IMPORTANT:
Make sure it is a cold water pipe.
Horizontal pipe will work, but drill on the top side of the
pipe, not the bottom. This will help keep water away from
the drill and normal sediment from collecting in the valve.
4. Determine the length of copper tubing you need. Measure
from the connection on the lower rear corner of refrigerator to
the water pipe. Add 7 ft (2.1 m) to allow for cleaning. Use ¹⁄₄"
(6.35 mm) O.D. (outside diameter) copper tubing. Be sure both
ends of copper tubing are cut square.
5. Using a cordless drill, drill a ¹⁄₄" (6.35 mm) hole in the cold
water pipe you have selected.
6. Fasten the shutoff valve to the cold water pipe with the pipe
clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm)
drilled hole in the water pipe and that the washer is under the
pipe clamp. Tighten the packing nut. Tighten the pipe clamp
screws slowly and evenly so the washer makes a watertight
seal. Do not overtighten, or you may crush the copper tubing.
7. Slip the compression sleeve and compression nut on the
copper tubing as shown. Insert the end of the tubing into the
outlet end squarely as far as it will go. Screw the compression
nut onto outlet end with adjustable wrench. Do not
overtighten.
8. Place the free end of the tubing in a container or sink, and turn
ON the main water supply. Flush the tubing until water is clear.
Turn OFF the shutoff valve on the water pipe. Coil the copper
tubing.
Connect to Refrigerator
Style 1
1. Unplug refrigerator or disconnect power.
2. Remove and discard the short, black plastic part from the end
of the water line inlet.
3. Thread the nut onto the end of the tubing. Tighten the nut by
hand. Then tighten it with a wrench two more turns. Do not
overtighten.
NOTE: To avoid rattling, be sure the copper tubing does not
touch the cabinet’s side wall or other parts inside the cabinet.
4. Install the water supply tube clamp around the water supply
line to reduce strain on the coupling.
5. Turn shutoff valve ON.
6. Check for leaks. Tighten any connections (including
connections at the valve) or nuts that leak.
Style 2
1. Unplug refrigerator or disconnect power.
2. Remove and discard the plastic part that is attached to the
inlet of the water valve.
3. Attach the copper tube to the valve inlet using a compression
nut and sleeve as shown. Tighten the compression nut. Do not
overtighten.
4. Use the tube clamp on the back of the refrigerator to secure
the tubing to the refrigerator as shown. This will help avoid
damage to the tubing when the refrigerator is pushed back
against the wall.
5. Turn shutoff valve ON.
6. Check for leaks. Tighten any connections (including
connections at the valve) or nuts that leak.
7. On some models, the ice maker is equipped with a built-in
water strainer. If your water conditions require a second water
strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube
connection. Obtain a water strainer from your nearest
appliance dealer.
Style 3
1. Unplug refrigerator or disconnect power.
2. Remove and discard the black nylon plug from the gray water
tube on the rear of the refrigerator.
3. If the gray water tube supplied with the refrigerator is not long
enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in
order to connect the water tubing to an existing household
water line. Thread the provided nut onto the coupling on the
end of the copper tubing.
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten.
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
A. Cold water pipe
B. Pipe clamp
C. Copper tubing
D. Compression nut
E. Compression sleeve
F. Shutoff valve
G. Packing nut
A. Household water line
B. Nut (purchased)
C. Ferrule (purchased)
D. Refrigerator water tubing
A
B
C
DEF
G
D
A B C
A. Tube clamp
B. Tube clamp screw
C. Copper tubing
D. Compression nut
E. Valve inlet
A. Refrigerator water tubing
B. Nut (provided)
C. Bulb
D. Coupling (purchased)
E. Ferrule (purchased)
F. Nut (purchased)
G. Household water line
A
C
B
D
E
A B C D E F G
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

Comments to this Manuals

No comments

Philips QC5125/15 manuály

Uživatelské manuály a uživatelské příručky pro Zastřihovače vlasů Philips QC5125/15.
Poskytujeme 1 manuály pdf Philips QC5125/15 ke stažení zdarma podle typů dokumentů: Datový list






Další produkty a příručky pro Zastřihovače vlasů Philips

Modely Typ Dokumentu
QC5050/00 Datový list   Philips Hair Clipper QC5050, 2 stránky
NT9110/60 Datový list   Philips Nose, ear & eyebrow trimmer, Series 3000 NT9110/60, 2 stránky
QG3193/00 Datový list   Philips Grooming kit QG3193, 2 stránky
QC5015/10 Datový list   Philips QC5015, 2 stránky
QC5005/30 Datový list   Philips Hair clipper QC5005, 2 stránky
QC5055/00 Datový list   Philips Hair clipper QC5055/00, 2 stránky
QG3060/60 Datový list   Philips QG3060 6 in 1 Grooming kit Grooming kit, 2 stránky
QC5099 Datový list   Philips QC5099/00 Hair Clipper, 2 stránky
QC5005/00 Datový list   Philips QC5005 Hair Clipper, 2 stránky
QC5055/40 Datový list   Philips Hair clipper QC5055/40, 2 stránky
QC5045/00 Datový list   Philips Hair clipper QC5045, 2 stránky
0QC5770/80 Datový list   Philips QC 5770/80, 2 stránky
QC5070/80 Datový list   Philips Hair clipper QC5070/80, 2 stránky
QC5115/15 Datový list   Philips Hair clipper QC5115, 2 stránky
HC9490 Uživatelský manuál        Philips HC9490 [no] , 9 stránky
QC5380/80 Datový list   Philips hair clipper QC5380, 2 stránky
HC7450/80 Uživatelský manuál     Philips HC7450/80 Panduan pengguna, 90 stránky
QC5570/32 Uživatelský manuál         Philips QC5570/15 Benutzerhandbuch, 150 stránky
QC5010/00 Datový list   Philips Hair clipper QC 5010, 2 stránky
QC5055/40 Uživatelský manuál   Philips QC5055/40 User manual, 10 stránky