Whirlpool AKT 352/IX Instruction for Use download pdf

AKT 352

400011091602

PRODUCT DESCRIPTION SHEET

1. Removable grid(s)

2. Semi-rapid burner

3. Rapid burner

4. Semi-rapid burner control knob

5. Rapid burner control knob

SYMBOLS

Tap closed

Max. ame

Min. ame

LIGHTING THE BURNERS

• To ignite one of the burners, turn the relative knob anticlockwise to the maximum ame setting .

• Press the knob against the control panel to ignite the burner.

• After the burner has ignited, keep the knob pressed for about 5 seconds to allow the thermocouple to warm up.

• This safety device shuts off the gas if the ame goes out accidentally (draughts, interruption of gas, liquids boiling over, etc.).

• The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute

before trying to light it again.

• The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. In this case, repeat the operations

described above.

PRATICAL ADVICE FOR USING THE BURNERS

For optimum burner performance, observe the following rules:

• Use pots and pans that t the burners (see table on the right).

• Only use at-bottomed pots and pans.

• Use the correct amount of water for cooking foods and keep the pot covered.

Burner Pot Ø

Rapid

Semi-rapid

From 24 to 26 cm

From 16 to 22 cm

DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)

NOTE: In the event a hood is tted above the cooktop, please refer to

the hood instructions for the correct distance.

ES IT PT

1 2 3 4 5

Summary of Contents

Page 1 - Burner Pot Ø

AKT 352EN400011091602PRODUCT DESCRIPTION SHEET125341. Removable grid(s)2. Semi-rapid burner3. Rapid burner4. Semi-rapid burner control knob5. Rap

Page 2 - INJECTOR TABLE

INJECTOR TABLECATEGORY II2H3+ELECTRIC SUPPLY: 230 V ~ 50 HzTy pe of gas used Ty pe of burnerInjectormarkingNominal heating capacity kWNominal consumpt

Page 3 - GAS CONNECTION

SAFEGUARDING THE ENVIRONMENT• PackagingThe packaging material is entirely recyclable, and is marked with the recycling symbol , which identies it a

Page 4 - ELECTRICAL CONNECTION

ELECTRICAL CONNECTION• The electrical connections must comply with local regulations.• The data relevant to the voltage and power absorption are ind

Page 5 - CLEANING THE HOB SURFACE

CARE AND MAINTENANCETo maintain your hob in perfect conditions, clean it after every use, removing any food spills.Before any cleaning operation, disc