Whirlpool AGS 840/WP Installation Manual download pdf (Page 13)

INSTALLATION

The ice cube maker is delivered on a small wooden pallet and is protected with a cardboard box and

packaging. Loosen the cardboard box by cutting the straps, then lift vertically.

After having removed the packaging, make sure the machine is complete. If in doubt do not use it and go to

the distributor who sold it to you.

This operation has to be performed with the wooden base structure firmly placed on the ground. All packaging

elements (plastic bags, cartons, etc..) must not be left at children's reach, since they are a potential source of

danger.

Place the machine where it is to be installed, and verify, using a level control, that the machine is in a

horizontal position.

CAUTION:

If the gap between the back of the machine and the wall of the room/bar is not sufficient, or if it is going to

receive hot air from another machine, we strongly advise, in case of not being able to change the location of

the machine, to

INSTALL A WATER-COOLED MACHINE.

Bear in mind the previous considerations if the premises where the machines is located are very dusty, or

smoky. If possible make arrangements so that the machine may be moved front-wise in order to carry out

maintenance.

Recommended Placement of Unit

AGS machines are intended to operate at room temperature between 5°C and 43°C and with water

temperature ranging between 5°C and 35°C. Below recommended minimum temperatures, ice cubes will be

un-stick correctly and may form a slab or block of ice. Operation carried out over maximum recommended

temperatures can result in shorter compressor life and decreased production.

Air-cooled units receive air input via front of machine and expel air through rear grill.

IMPORTANT!

If front and/or rear ventilation is inadequate, obstructed, or in close proximity to other heat producing

machinery, USE OF A WATER-COOLED UNIT is strongly recommended.

Water inlet tube should not pass near heat sources: water entering the machine should be as cold as

possible, but always above 5ºC.

The above mentioned also applies should unit be installed in an area where dust, smoke, or other airborne

pollutants may be present. Units—especially air-cooled—should not be installed in kitchens. To facilitate

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

No comments

Whirlpool AGS 840/WP Installation Manual Page 13