Whirlpool GSC308PRQ User Manual download pdf

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

Tools needed

Parts needed

■ A UL listed or CSA approved conduit connector

■ UL listed wire nuts

Parts supplied

■ 2 screws (single oven) or 4 screws (double oven)

Check local codes. Check existing electrical supply. See

“Electrical Requirements.”

All electrical connections should be made by a licensed, qualified

electrical installer.

Location Requirements

Make sure you have everything needed for correct installation. It is

the responsibility of the installer to comply with the installation

clearances specified in these instructions.

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance with oven.

■ Recessed installation area must provide complete enclosure

around the recessed portion of the oven.

■ Grounded electrical supply is required. See “Electrical

Requirements” section.

■ Electrical supply junction box should be located 3" (7.6 cm)

maximum below the support surface when the oven is

installed in a wall cabinet. Drill a 1" (2.5 cm) minimum diameter

hole in the right rear or left rear corner of the support surface

to pass the appliance cable through to the junction box.

■ Oven support surface must be solid, level and flush with

bottom of cabinet cutout. Floor must be able to support a total

weight (microwave and built-in oven) of 238 lbs (108 kg).

Product Dimensions

27" (68.6 cm) and 30" (76.2 cm) Ovens

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO

EXCESSIVE MICROWAVE ENERGY

(a) Do not attempt to operate this oven with the door open

since open-door operation can result in harmful exposure

to microwave energy. It is important not to defeat or

tamper with the safety interlocks.

(b) Do not place any object between the oven front face and

the door or allow soil or cleaner residue to accumulate on

sealing surfaces.

important that the oven door close properly and that there

is no damage to the:

(1) Door (bent),

(2) Hinges and latches (broken or loosened),

(3) Door seals and sealing surfaces.

(d) The oven should not be adjusted or repaired by anyone

except properly qualified service personnel.

■ Phillips screwdriver

27" (68.6 cm) models

A. 25

³⁄₈

" (64.5 cm) recessed width

B. 42

⁷⁄₁₆

" (107.8 cm) overall height

C. 26

³⁄₄

" (67.9 cm) overall width

D. 23" (58.4 cm) max. recessed

depth

E. 41" (104.1 cm) recessed height

30" (76.2 cm) models

A. 28

³⁄₈

" (71.2 cm) recessed width

B. 42

⁷⁄₁₆

" (107.8 cm) overall height

C. 29

³⁄₄

" (75.6 cm) overall width

D. 23" (58.4 cm) max. recessed

depth

E. 41" (104.1 cm) recessed height

1 2 3 4 5 6

Summary of Contents

Page 1 - INSTALLATION REQUIREMENTS

2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation.Tools neededParts needed A UL listed or CSA

Page 2 - Electrical Requirements

3 Installation Clearances 27" (68.6 cm) and 30" (76.2 cm) Ovens Cabinet Side View Cabinet filler kits are available from your dealer. Use ma

Page 3 - INSTALLATION INSTRUCTIONS

4INSTALLATION INSTRUCTIONSPrepare Oven for Installation1. Decide on the final location for the oven. Locate existing wiring to prevent drilling into o

Page 4 - (8.9 cm)

56. Complete installation following instructions for your type of electrical connection:4-wire (recommended)3-wire (if 4-wire is not available)Electri

Page 5 - Complete Installation

2. Push against seal area of front frame to push oven completely into cabinet and center oven into cabinet cutout.3. Securely fasten oven to cabinet u

Page 6 - MICROWAVE/OVEN COMBINATION

INSTALLATION INSTRUCTIONS27" (68.6 CM) AND 30" (76.2 CM) ELECTRIC BUILT-INMICROWAVE/OVEN COMBINATIONBUILT-IN MICROWAVE/OVEN COMBINATION SAFE