Whirlpool WFG114SWB User Manual

INSTALLATION INSTRUCTIONS30" (76.2 CM) FREESTANDING GAS RANGESwith standard clean ovenTable of ContentsRANGE SAFETY...

10Electronic Ignition SystemInitial lighting and gas flame adjustmentsCooktop and oven burners use electronic igniters in place of standing pilots. Wh

11If the flame needs adjusting:1. Turn the oven off. Wait for the oven burner to cool down.2. Open oven door and remove oven racks, oven tray, flame s

12GAS CONVERSIONSGas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer.LP Gas ConversionTo Co

13To Convert Surface Burners1. Remove burner grate, burner caps and burners. 2. Locate LP gas orifice spuds for top burners in the literature bag incl

14Complete Conversion1. Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.2. Turn the manual shutoff valv

15To Convert Surface Burners1. Remove burner grate, burner caps and burners. 2. Locate the Natural gas orifice spuds for top burners in the literatur

W10032050B© 2009.All rights reserved.9/09Printed in Mexico

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Mobile Home - Additional Installation RequirementsThe installation of this range must conform to the Manufactured Home Construction and Safety Standa

5Electrical RequirementsIMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local c

6Gas Supply Line Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in in

7INSTALLATION INSTRUCTIONSUnpack Range1. Do not use oven door handle to lift or move the range2. Remove shipping materials, tape and film from range.

87. Move range close enough to the opening to allow for final electrical connection. Remove shipping base, cardboard or hardboard from under range.8.

93. Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked. Complete Connection1.